Free vibration analysis of double-bonded isotropic piezoelectric Timoshenko microbeam based on strain gradient and surface stress elasticity theories under initial stress using differential quadrature method
M. Mohammadimehr,H. Mohammadi Hooyeh,H. Afshari,M. R. Salarkia
DOI: https://doi.org/10.1080/15376494.2016.1142022
2016-09-13
Mechanics of Advanced Materials and Structures
Abstract:The size-dependent effect on free vibration of double-bonded isotropic piezoelectric Timoshenko microbeams using strain gradient and surface stress elasticity theories under initial stress is presented. This article is developed for isotropic piezoelectric material. Due to the high surface-to-volume ratio, surface stress has an important role with micro- and nanoscale materials. Thus, the Gurtin–Murdoch continuum mechanic approach is used. Governing equations of motion are derived by Hamilton's principle and solved by the differential quadrature method. The effects of pre-stress load, surface residual stress, surface mass density, surface piezoelectrics, Young's modulus of surface layers, three material length scale parameters, thickness to material length scale parameter ratios, various boundary conditions, and two elastic foundation coefficients are investigated. It is concluded that the effect of pre-stress load in greater modes is negligible for higher aspect ratios and this effect is similar to lower aspect ratios. Also, the size-dependent effect on the dimensionless natural frequency for strain gradient theory is higher than that for modified couple stress theory and classical theory, which is due to increasing stiffness of the Timoshenko microbeam model. Moreover, the results show that dimensionless natural frequency affects more by considering the material length scale parameters with respect to surface effect. The results are compared with the obtained results from the literature and show good agreement between them. It is concluded that the amplitude of the transverse displacements (w0) for a microbeam (MB) is more than the transverse displacements (w1) for a piezoelectric microbeam (PMB). On the other hand, using a piezoelectric layer for PMB, the amplitude of the transverse displacements (w1) reduces considerably with respect to MB, in which this effect leads to increase the stiffness of the microbeam and stability of microstructures. With considering the piezoelectric layer, the obtained results can be used to control the amplitude and vibration of microstructures, prevent the resonance phenomenon, design smart structures, and can be employed for micro-electro-mechanical systems and nano-electro-mechanical systems.
materials science, multidisciplinary,mechanics, composites, characterization & testing