Modeling an elastic beam with piezoelectric patches by including magnetic effects

A.O. Ozer,K.A. Morris

DOI: https://doi.org/10.1109/ACC.2014.6858862

2014-03-25

Abstract:Models for piezoelectric beams using Euler-Bernoulli small displacement theory predict the dynamics of slender beams at the low frequency accurately but are insufficient for beams vibrating at high frequencies or beams with low length-to-width aspect ratios. A more thorough model that includes the effects of rotational inertia and shear strain, Mindlin-Timoshenko small displacement theory, is needed to predict the dynamics more accurately for these cases. Moreover, existing models ignore the magnetic effects since the magnetic effects are relatively small. However, it was shown recently \cite{O-M1} that these effects can substantially change the controllability and stabilizability properties of even a single piezoelectric beam. In this paper, we use a variational approach to derive models that include magnetic effects for an elastic beam with two piezoelectric patches actuated by different voltage sources. Both Euler-Bernoulli and Mindlin-Timoshenko small displacement theories are considered. Due to the magnetic effects, the equations are quite different from the standard equations.

Analysis of PDEs,Classical Physics

What problem does this paper attempt to address?

This paper attempts to solve the following problems:

1. **Limitations of existing models**:
- Traditional piezoelectric beam models based on the Euler - Bernoulli (E - B) small - displacement theory can accurately predict dynamic behaviors in the case of low - frequency vibrations and slender beams, but perform poorly in the case of high - frequency vibrations or beams with a low length - to - width ratio (short and thick).
- Existing models usually ignore magnetic effects because these effects are relatively small. However, recent research shows that magnetic effects can significantly change the controllability and stability of a single piezoelectric beam.

2. **Introduction of a more comprehensive model**:
- The paper proposes to use the Mindlin - Timoshenko (M - T) small - displacement theory for modeling, which not only includes shear strain and rotational inertia effects but also takes into account the influence of magnetic effects. This enables the model to more accurately describe the dynamic behaviors of high - frequency vibrations or short and thick beams.

3. **Influence of magnetic effects on the system**:
- Research shows that the existence of magnetic effects will significantly affect the controllability and stability of piezoelectric beams. Therefore, the paper derives an elastic beam model including magnetic effects through the variational principle and analyzes its influence on the dynamic behaviors of the system.

4. **Multi - physical field coupling**:
- In traditional models, electromagnetic components and mechanical components are usually decoupled. In this paper, by introducing magnetic effects, the coupling of electromagnetic components and mechanical components is achieved, thus more realistically reflecting the dynamic characteristics of the actual system.

In summary, the main objective of this paper is to establish a more accurate piezoelectric beam dynamic model by introducing magnetic effects and using a more comprehensive mechanical theory (such as the Mindlin - Timoshenko theory), in order to overcome the deficiencies of existing models in high - frequency vibrations and complex geometries, and to study the influence of magnetic effects on the controllability and stability of the system.

### Formula presentation

To understand the above problems more clearly, some key formulas are listed here:

- **Linear constitutive relation**:
\[
\begin{pmatrix}
T \\
D
\end{pmatrix}
=
\begin{pmatrix}
[c] & -[\Gamma]^T \\
[\Gamma] & [\varepsilon]
\end{pmatrix}
\begin{pmatrix}
S \\
E
\end{pmatrix}
\]
where \( T \) is the stress vector, \( S \) is the strain vector, \( D \) and \( E \) are the electric displacement and electric field vectors respectively, and \([c]\), \([\Gamma]\) and \([\varepsilon]\) are the elastic, electromechanical and dielectric constant matrices respectively.

- **Maxwell equations**:
\[
\begin{cases}
\nabla \cdot D=\sigma_b & \text{in } \Omega\times\mathbb{R}^+ \\
\nabla \cdot B = 0 & \text{in } \Omega\times\mathbb{R}^+ \\
\nabla \times E=-\dot{B} & \text{in } \Omega\times\mathbb{R}^+ \\
\frac{1}{\mu}(\nabla \times B)=i_b+\dot{D} & \text{in } \Omega\times\mathbb{R}^+
\end{cases}
\]

- **Energy expressions**:
- Kinetic energy \( K \):
\[
K=\frac{\rho}{2}\int_{\Omega}(\dot{U}_1^2+\dot{U}_3^2)dX
\]
- Potential energy \( P + E \):
\[
P + E=\frac{1}{2}