Abstract:Abstract: Novel nanostructured iron oxide-reduced graphene oxide composites were synthesized by a facile one-step hydrothermal method in an ethylene glycol (EG)–water system. Different phases of iron oxides were detected by adjusting fabrication parameters including the EG/H2O ratio, base content and iron ions concentration. Electrochemical propertyof fabricated nanocomposites as anode material was examined in a coin–type cell. The high–rate capacity and cycling stability were found, which is attributed to the improved lithium storage capability due to the application of graphene sheet acting as conductive materials for iron oxide nanoparticles. This study provides a favorable approach for exploring the nanocomposites of metal oxide-graphene anode for lithium ion battery applications. Introduction: Currently,α–Fe2O3 has been considered as a promising candidate for lithium ion batteries due to its much higher theoretical capacity of 1350 mAhg‾1 than that of commercial graphite anode materials and its environmental friendly fabrication methods from low–cost resources [1]. In particular, the use of nanomaterials is an effective path to improve rate capabilities of solid state electrodes in batteries attributed to their relatively small diffusion lengths. Furthermore,graphene, with an excellent electronic conductivity, a high theoretical surface area of 2630 m2/g and superior mechanical properties, is a significantly promising component for high performance electrode materials [2]. In this study, an anode material of iron oxide nanoparticles (mainly α–Fe2O3)–reduced graphene oxide for lithium ion battery has been synthesized and reported. Experimental: FeCl3·6H2O (1.08 g) and NaOH (0.8 g) was dissolved in EG (30 ml) by ultrasonication for 1 hour.Then 10 ml deionized water and 15 mg graphene oxide was added to the mixture under stirring to get a homogeneous solution. The solution was transferred into a 50 ml teflon–lined stainless steel autoclave, sealed and heated at 200oC for 10 hours. The product was collected by centrifuging and washed by ethanol and deionized water alternatively for several times, which was followed by drying at 80oC. Morphologies and phases of synthesized nanocomposites were characterized by scanning electron microscopy (SEM), Raman scattering spectroscopy, X-ray diffraction (XRD), high resolution transmission electron microscopy(TEM). Results: Typical XRD pattern of the products was illustrated in Fig.1 that demonstrated the co–existence of α–Fe2O3 and Fe3O4. Diffraction peaks can be indexed to either the rhombohedral phase of α-Fe2O3 (JCPDS NO.84-0307) or the cubic phase of Fe3O4 (JCPDS NO.65-3107). The characteristic peak of graphene oxide located at 10.4° was not found, confirming the formation of graphene. Fig. 1 also showed the SEM image of fabricated iron oxide nanoparticles that were uniform with the diameter about 50 nm, indicating XRD pattern in good agreement with SEM results. Raman spectra also confirmed that the typical features of reduced graphene oxide with the presence of D band (1348 cm−1) and G band (1598 cm−1). References: [1] P. C. Wang, H. P. Ding, Tursun Bark, and C. H. Chen, Electrochimica Acta,52 (2007) 6650–6655 [2] S. Stankovich, D. A. Dikin, G. H. B. Dommett, K.M. Kohlhaas, E. J. Zimney, E. A. Stach, R. D. Piner, S.T. Nguyen, and R.S. Ruoff, Nature, 442 (2006) 282–286

Effects of Alumina Films on N-Doped Carbon Nanotubes/Graphene Composites as Anode Materials of Lithium-Ion Batteries

Nanocomposites As Anode for Lithium-Ion Battery

Nanocomposite of Iron Oxide-Reduced Graphene Oxide Applied As High-Performance Anode Materials for Lithium Ion Batteries

N-Doped Graphene Quantum Dots Supported by Carbon Nanotubes Grown on Carbon Clothes for Lithium Storage

Advancing Lithium-Ion Batteries' Electrochemical Performance: Ultrathin Alumina Coating on Li(Ni0.8Co0.1Mn0.1)O2 Cathode Materials

Nano-TiNb2O7/carbon Nanotubes Composite Anode for Enhanced Lithium-Ion Storage

Ultrathin Co3O4 Nanosheet Clusters Anchored on Nitrogen Doped Carbon Nanotubes/3d Graphene As Binder-Free Cathodes for Al-air Battery

Ionic Liquid Derived Co3O4/Nitrogen Doped Carbon Composite As Anode of Lithium Ion Batteries with Enhanced Rate Performance and Cycle Stability

Binder-Free CoMn2O4 Nanoflower Particles/Graphene/Carbon Nanotube Composite Film for a High-Performance Lithium-Ion Battery

Tailoring the Li+ Intercalation Energy of Carbon Nanocage Anodes Via Atomic Al‐Doping for High‐Performance Lithium‐Ion Batteries

Preparation of A Carbon Nanofiber/Natural Graphite Composite and an Evaluation of Its Electrochemical Properties As an Anode Material for A Li-Ion Battery

Stable Cyclic Performance of Nickel Oxide–carbon Composite Anode for Lithium-Ion Batteries

Three-dimensional Composite Catalysts for Al-O2 Batteries Composed of CoMn2O4 Nanoneedles Supported on Nitrogen-Doped Carbon Nanotubes/Graphene.

A Magnetite Nanocrystal/graphene Composite As High Performance Anode for Lithium-Ion Batteries

Ultrathin Aluminum Nanosheets Grown on Carbon Nanotubes for High Performance Lithium Ion Batteries

Efficacy of atomic layer deposition of Al2O3 on composite LiNi0.8Mn0.1Co0.1O2 electrode for Li-ion batteries

Improving High-Capacity Li1.2Ni0.15Mn0.55Co0.1O2-based Lithium-Ion Cells by Modifiying the Positive Electrode with Alumina

High Rate Capability of TiO2/nitrogen-doped Graphene Nanocomposite As an Anode Material for Lithium–ion Batteries

A Tripartite Composite Incorporating Nitrogen-Doped Graphene Oxide, Polypyrrole, and Silica for Lithium-Ion Battery Anodes

Synthesis and Properties of LiFePO4/LiNi0.8Co0.15Al0.05O2 Composite Cathode Material Modificated by Graphene for Lithium Ion Battery

Facile Preparation of Co@Co3O4@Nitrogen Doped Carbon Composite from Ionic Liquid As Anode Material for High Performance Lithium-Ion Batteries