Effect of different surface treatments and adhesive cementation on the surface topography and flexural strength of translucent and ultra‐translucent monolithic zirconia

Bianca Cristina Dantas da Silva,Sarah Emille Gomes da Silva,Nathália Ramos da Silva,Fernanda Gurgel Gois de Moreira,Karina Barbosa Souza,Yu Zhang,Rodrigo Othávio Assunção de Souza

DOI: https://doi.org/10.1111/jopr.13929

2024-08-30

Journal of Prosthodontics

Abstract:Purpose To evaluate the effect of different surface treatments and adhesive cementation on the miniflexural strength (MFS) of monolithic zirconia. Materials and Methods Two‐hundred and forty (240) sintered bars of translucent zirconia (ZT) and ultra‐translucent zirconia (ZUT) were obtained (8 mm ×2 mm ×1 mm). The bars were divided into 16 groups (n = 15) according to the factors "Zirconia" (ZT and ZUT), "Cementation" (Cem) and "surface treatment" (Ctrl:Control, Al:Aluminum oxide/Al2O3 50 μm, Si:Silica/SiO2 coated alumina particles oxide 30 μm, Gl:Glazing+hydrofluoric acid). Half of the bars received an adhesive layer application, followed by application of resin cement and light curing. The surface roughness was measured in non‐cemented groups. All the bars were subjected to the MFS test (1.0 mm/min; 100 kgf). Scanning electron microscopy was used for qualitative analyses. MFS data (MPa) and roughness (μm) were statistically evaluated by three‐way and two‐way ANOVA respectively and Tukey's test (5%). Results The surface treatment and the interaction were significant for roughness. Glazing promoted less roughness compared to silicatization. Regarding MFS, only the zirconia and surface treatment factors were significant. For ZT, the sandblasted groups had an increase in MFS and glazing reduced it. There was no difference between the groups without cementation for the ZUT; however, ZUT.Si/Cem, and ZUT.Al/Cem obtained superior MFS among the cemented groups. Conclusions Sandblasting increases the flexural strength for ZT, while glaze application tends to reduce it. Applying resin cement increases the flexural strength of ZUT when associated with sandblasting. Sandblasting protocols promote greater surface roughness.

dentistry, oral surgery & medicine