Abstract:Different propulsion systems can be used for launching payloads into orbit and for attitude control, orbit correction and maneuvering of satellites. Liquid bipropellant thrusters are used in applications requiring high specific impulses and high thrust levels and numerical simulation models can reduce development costs and time. This work describes a new 2D numerical model based on the boundary layer equations for the simulation of spray combustion. This model can be applied to the preliminary design of rocket combustion chambers, and allows the determination of droplet vaporization lengths, chemical composition, temperature profile and other thermodynamic and propulsion parameters. The computation time is, in general, lower than more complex 2D and 3D simulation models. Liquid fuel and oxidizer are injected into the combustion chamber with known droplet sizes and a pre-existing gas flow, which represents combustion products recirculation. The governing equations are discretized using centered and backward finite differences and the solution is marched downstream, considering droplet evaporation, mixture and combustion of propellant vapors with pre-existing gases. Burning of unsymmetrical dimethylhydrazine (UDMH) and dinitrogen tetroxide (NTO) was simulated with different mixture conditions and taking into account eleven product species. The model was validated by considering separately the different routines, comparing results of internal boundary layer flows, droplet evaporation and combustion products composition against expected theoretical behavior and results from other models. The influence of the equivalence ratio radial distribution on flow parameters was evaluated. The gas temperatures near the wall remained relatively constant after a certain distance downstream, depending on the local equivalence ratio distribution. The boundary layer remained very thin along the chamber due to the constant addition of combustion products.

Investigation and assessment of production- and dissipation-limited DDES methods for rocket combustion chamber simulations

Assessment of turbulence-chemistry interaction models in MILD combustion regime

Direct numerical simulations of rich premixed turbulent n-dodecane/air flames at diesel engine conditions

Delayed Detached-Eddy Simulations of Rough-Wall Turbulent Reactive Flows in a Supersonic Combustor

Direct Numerical Simulations and Analysis of Three-Dimensional N-Heptane Spray Flames in a Model Swirl Combustor

Evaluation of Numerical Dissipation Sensitivity Using IDDES

Iddes Simulation of Supersonic Combustion Using A Compressible Flamelet Modeling

IDDES Method Based on Differential Reynolds-stress Model and Its Application in Bluff Body Turbulent Flows

Numerical Dissipation Effects on Detached Eddy Simulation of Turbomachinery Flows

Experimental and Numerical Investigation of the Non-Reacting Flow in a High-Fidelity Heavy-Duty Gas Turbine DLN Combustor

Studies on a Swirling Heptane Spray Flame by Large-Eddy Simulation

Simulation of Turbulent Combustion in DLR Scramjet

IDDES simulation of hydrogen-fueled supersonic combustion based on dynamic zone flamelet model

Improved delayed detached eddy simulation of supersonic combustion fueled by liquid kerosene

IDDES simulation of hydrogen-fueled supersonic combustion using flamelet modeling

A two-dimensional boundary layer model for combustion chamber simulation

Numerical simulation of Delft-jet-in-hot-coflow (DJHC) flames using the Eddy Dissipation Concept model for turbulence-chemistry interaction

Detached-eddy simulation k-ε turbulence model and its application in fire simulations

Comparisons of Three Improved DES Methods on Unsteady Flows Past Tandem Cylinders

Numerical Investigation of Work Cycle Characteristics in the Combustion Chamber of a Lox/Methane Liquid-Propellant Rocket Engine Featuring Reductant Power Gas Combustion

Investigation of Very Large Eddy Simulation Method for Applications of Supersonic Turbulent Combustion