Abstract:More than one million tons of secondary aluminum dross as a hazardous waste are produced by aluminum manufacturers per year throughout the world, which imposes high disposal costs and serious environmental problems. As secondary aluminum dross is considered as an alumina-rich inorganic waste, this study aims to propose a promising approach for clean production of activated-alumina as a widely-used adsorbent, catalyst and catalyst support. In this paper, synthesis and characterization of high crystalline activated-alumina nanopowder from secondary aluminum dross using a novel five-step leaching-based process are presented. To optimize the process, various parameters of dross particle size, leaching time, leaching temperature, acid concentration, and liquid-to-solid ratio were studied using One-Factor-At-a Time approach (OFAT). For the following optimum leaching conditions: particle sizes between 38 and 75 μm, leaching time of 120 min, leaching temperature of 85 °C, acid concentration of 5 M, and the liquid-to-solid ratio of 20 ml/g, the extraction efficiency of alumina was around 83%. The leach liquor was purified by adding 2 N NaOH resulting in sodium aluminate-rich solution. The purified liquor was treated by adding HCl to precipitate Al(OH)3, and the Al(OH)3 was then washed and calcined at 700 °C for 2 h to obtain alumina. Chemical composition, mineralogical phases, chemical bonds, morphology, and particle size distribution of the as-synthesized activated-alumina were determined using X-ray fluorescence (XRF), X-ray diffractometry (XRD), Fourier transform infrared (FTIR) spectroscopy, field emission scanning electron microscopy (FESEM), and dynamic light scattering (DLS), respectively. The as-synthesized activated-alumina exhibited 97.61% purity. Its XRD pattern showed mainly characteristic peaks of gamma phase of alumina. Morphological study by FESEM revealed that the as-synthesized alumina particles have rounded-corner shape. The crystal and average particle size values were about 18.47 and 513 nm, respectively.

Extracting aluminum from dross tailings

Surface and Bulk Properties of Alumina Recovered Under Various Conditions from Aluminum Dross Tailings Chemical Waste Versus Bauxite Ore

Extraction of alumina from aluminum dross by a non-hazardous alkaline sintering process: Dissolution kinetics of alumina and silica from calcined materials

Mechanism study of synergistic aluminum extraction and purification by ammonium for high-value conversion of secondary aluminum dross

Preparation of aluminium-magnesium alloys and some valuable salts from used beverage cans

Synthesis of submicronic α-alumina from local aluminum slags

Manganese and Aluminium Recovery from Ferromanganese Slag and Al White Dross by a High Temperature Smelting-Reduction Process

Valorization of Aluminum Dross with Copper via High Temperature Melting to Produce Al-Cu Alloys

A promising green process for synthesis of high purity activated-alumina nanopowder from secondary aluminum dross

Research on synergistic disposal and high-value utilization of secondary aluminum dross and spent carbon anode

Aluminum Extraction from Coal Ash by a Two-Step Acid Leaching Method

Research on the Preparation Parameters and Basic Properties of Premelted Calcium Aluminate Slag Prepared from Secondary Aluminum Dross

A cleaner electrolysis process to recover alumina from synthetic sulfuric acid leachate of coal fly ash

Extraction of aluminum values from fly ash

Recovery of aluminum from waste aluminum alloy by low-temperature molten salt electrolysis

A New Extraction Mechanism in Sulfuric Acid Media for the Recovery of Aluminum

Extraction of alumina from coal fly ash generated from a selected low rank bituminous South African coal

Comprehensive treatments of aluminum dross in China: A critical review

Thermogravimetry as a research tool for the development of an ammonium sulphate roasting process for selective metal extraction from minerals