Deformation mechanism and microstructure evolution of medium-Mn AHSS under various loading conditions

Changwei Lian,Haiming Zhang,Jianping Lin,Li Wang

DOI: https://doi.org/10.1016/j.ijmecsci.2021.106812

IF: 7.3

2021-12-01

International Journal of Mechanical Sciences

Abstract:Third-generation advanced high-strength steels possess an exceptional combination of high strength and ductility owing to their high work-hardening rate during deformation. In this study, the mechanical properties and microstructure/texture evolution of medium-Mn steel under various loading conditions (uniaxial tension, in-plane torsion, and equibiaxial tension) were investigated. Interrupted electron back-scattered diffraction and X-ray diffraction characterizations were carried out to track the microstructure and texture evolution of individual phases. Digital image correlation was employed for the in-situ measurement of formation and expansion of deformation bands, i.e., the Lüders and the Portevin-Le Châtelier (PLC) bands. The dynamic strain aging effect in terms of the formation of PLC bands and stress serrations was significantly affected by the loading conditions and stress level. Multiple types of stress serrations were observed in all tested specimens at different deformation stages. The texture evolution of the steel under various deformation modes was further tracked. Ferrite and fresh martensite exhibited the plain texture evolution like most body-centered cubic metals, whereas austenite showed a more complex texture evolution. The martensitic transformation notably decreased the RD||<001> intensity of the austenite; austenite debris was rotated with ferrite grains, while some intact austenite grains self-rotated to a stable orientation, which is unfavorable for martensitic transformation. The obvious intragranular orientation gradient observed in the austenite intact grains implies that considerable deformation occurred in the austenite. Finally, the experimental results indicate that equibiaxial tension primarily promoted the martensitic transformation, and the classical Olson–Cohen model was calibrated to capture the volume fraction evolution of austenite under various stress states.

engineering, mechanical,mechanics