Abstract:In the current study, dislocation activity and storage during creep deformation in a nickel based superalloy (Waspaloy) were investigated, focussing on the storage of geometrically necessary (GND) and statistically stored (SSD) dislocations. Two methods of GND density calculation were used, namely, EBSD Hough Transformation and HR-EBSD Cross Correlation based methods. The storage of dislocations, including SSDs, was investigated by means of TEM imaging. Here, the concept of GND accumulation in soft and hard grains and the effect of neighbouring grain orientation on total dislocation density was examined. Furthermore, the influence of applied stress (below and above the yield stress of Waspaloy) during creep on deformation micro-mechanism and dislocation density was studied. It was demonstrated that soft grains provided pure shear conditions on at least two octahedral (111) slip systems for easy dislocation movement. This allowed dislocations to reach the grain boundary without significant geometrically necessary dislocation accumulation in the centre of the grain. Hence, the majority of the soft grains appeared to have minimum GND density in the centre of the grain with high GND accumulation in the vicinity of the grain boundaries. However, the values and width of accumulated GND depended on the surrounding grain orientations. Furthermore, it was shown that the hard grains were not favourably oriented for octahedral slip system activation leading to a grain rotation in order to activate any of the available slip systems. Eventually, (i) the hard grain resistance to deformation and (ii) neighbouring grain resistance for the hard grain reorientation caused high GND density on a number of octahedral (111) slip systems. The results also showed that during creep below the yield stress of Waspaloy (500 MPa/700 °C), the GND accumulation was relatively low due to the insufficient macroscopic stress level. However, the regions near grain boundaries showed high GND density. At 800 MPa/700 °C (above yield at this temperature), in addition to the movement of pre-existing dislocations (SSD and GND) at a higher mobility rate, large numbers of dislocations were generated and moved toward the grain boundaries. This resulted in a much higher GND density but narrower width of high intensity GNDs near the grain boundaries. It is concluded that although GND measurement by means of EBSD can provide great insight into dislocation accumulation and its behaviour, it is critical to consider SSD type which also contributes to the strain hardening of the material.

Creep degradation assessment of a Super304H austenitic steel by using misorientation‐derived parameters (electron backscatter diffraction)

An Investigation of the Effect of High-Temperature Cyclic Straining and Creep Loading on Tensile Mechanical Properties of GH4145/SQ Alloy

Creep damage assessment of HR3C austenitic steel by using misorientation parameters derived from EBSD technique

Assessment of the creep damage in HR3C steel using the misorientation parameters derived from EBSD technique

Damage evaluation of the austenitic heat-resistance steel subjected to creep by using Kikuchi pattern parameters

Semi-quantitative creep-fatigue damage analysis based on diffraction-based misorientation mapping and the correlation to macroscopic damage evolutions

EBSD analysis of creep deformation induced grain lattice distortion: A new method for creep damage evaluation of austenitic stainless steels

Creep-fatigue Damage Level Evaluation Based on the Relationship Between Microstructural Evolution and Mechanical Property Degradation

Change of Grain Orientation and Effect of Grain Size on It in Creep Deformed Hastelloy X

Microstructure and Property Evolutions of a Novel Super304H Steel During High Temperature Creeping

Creep-fatigue life prediction in nickel-based superalloy GH4169 based on microstructural damage quantification with the help of electron backscatter diffraction

Evaluation of the Effect of Various Prior Creep-Fatigue Interaction Damages on Subsequent Tensile and Creep Properties of 9%cr Steel

Characterization of the Cyclic Softening and Remaining Creep Behaviour of P92 Steel Weldment

On the influence of grain morphology on creep deformation and damage mechanisms in directionally solidified and oxide dispersion strengthened superalloys

Microstructural evolutions and life evaluation of non-proportional creep-fatigue considering loading path and holding position effects

Investigation of fatigue mesoscopic mechanical properties of a nickel-based superalloy by instrumented microindentation measurements

Creep Behavior and a Deformation Mechanism Based Creep Rate Model under High Temperature and Low Stress Condition for Single Crystal Superalloy DD5

Investigation on Creep Deformation and Age Strengthening Behavior of 304 Stainless Steel under High Stress Levels

Intergranular precipitation behavior and its influence on the stress relaxation cracking susceptibility of Super304H austenitic stainless steel weld metal during long-term aging

The dislocation behaviour and GND development in a nickel based superalloy during creep

Effects of solution temperatures on creep resistance in a powder metallurgy nickel-based superalloy