Abstract:The performance of air-source heat pump is strongly influenced by ambient temperature variation. Improving its stability and efficiency during wintertime is important for promoting its applications, while existing studies paid few attentions to flexible parameter regulation of heat pump using mixture. In this paper, a single-stage compound air-source heat pump using ternary mixture was theoretically simulated and experimentally tested, in which operating parameters including pressure and concentration could be regulated with the cooperation of multiple valves and reservoirs. Using CO2/R134a/R600, operating pressure and mixture concentration were successfully regulated at ambient temperature from -30 & DEG;C to 0 & DEG;C, achieving a coefficient of performance from 1.834 to 2.546 when producing hot water at 75 & DEG;C. Whether R134a inclusion was favorable to energy performance depended on its influence on the temperature matching in recuperative process, especially the heat transfer process in recuperator. The addition of R134a significantly alleviated the increase of operating pressure and thus enlarged the operation range of this heat pump. The flammability range of CO2/R134a/R600 was calculated, indicating the insignificant influence of R134a on flammability retardance in the studied range of this paper. The significance of this study is further revealed with the potential advances of heat transfer technique and new-generation refrigerant. The findings in this paper contribute to: 1) the modification of air-source heat pump for operation at low temperature; 2) the regulation method for mixed-refrigerant system; 3) the exploration of new mixed-refrigerant in thermodynamic cycle.

Thermodynamic performance of heat pump with R1234ze(E)/R1336mzz(E) binary refrigerant

A thermodynamic analysis of a transcritical cycle with refrigerant mixture R32/R290 for a small heat pump water heater

Performance Assessment of Heat Pump Water Heaters with R1233zd(E)/HCs Binary Mixtures

Theoretical Investigation and Comparative Analysis of the Linde–Hampson Refrigeration System Using Eco-Friendly Zeotropic Refrigerants Based on R744/R1234ze(Z) for Freezing Process Applications

Experimental and Theoretical Assessments on the Systematic Performance of a Single-Stage Air-Source Heat Pump Using Ternary Mixture in Cold Regions

Vapor injected heat pump using non-azeotropic mixture R 32 / R 1234 ze ( E ) for low temperature ambient

Thermodynamic analysis of a dual-pressure evaporation high-temperature heat pump with low GWP zeotropic mixtures for steam generation

Thermodynamic properties of non-azeotropic refrigerant heat pumps under full operating conditions with non-phase-change heat sinks and heat soucres

Comparative Performance of Ternary Azeotropic Mixtures As Substitutes for R134a in Dual-Temperature Air Source Heat Pump Combined Ejector

Numerical Study of Gas Injected Heat Pump Using Zeotropic R32/R1234ze(E) Mixture: Comparison of Two Type Economizers

Experimental performance of moderately high temperature heat pump with working fluid R1234ze(Z)

Matching Characteristics of Refrigerant and Operating Parameters in Large Temperature Variation Heat Pump

Theoretical Performance Analysis of an Ejector Enhanced High-Temperature Heat Pump with Dual-Pressure Condensation and Evaporation

Comparison of Cycle Performance of HFO-1336mzz(Z)and HCFC-123 in Heat Pump System

Theoretical Performance Assessment of Low-GWP Refrigerant R1233zd(E) Applied in High Temperature Heat Pump System

Performance Of Refrigeration & Heat Pump System By Using Binary Mixtures Of R32/R744

Performance and Economic Analysis of Two Types of High-Temperature Heat Pump Based on New Refrigerants

Numerical investigations on the performance of a single-stage auto-cascade refrigerator operating with two vapor-liquid separators and environmentally benign binary refrigerants

Experimental Research on Vapor-Injected Water Source Heat Pump Using R1234ze(E)

Selection and Validation on Low-Gwp Refrigerants for a Water-Source Heat Pump

Numerical Research on R32/R1234ze(E) Air Source Heat Pump under Variable Mass Concentration