Abstract:The CMS tracker consists of two tracking systems utilizing semiconductor technology: the inner pixel and the outer strip detectors. The tracker detectors occupy the volume around the beam interaction region between 3 cm and 110 cm in radius and up to 280 cm along the beam axis. The pixel detector consists of 124 million pixels, corresponding to about 2 m$^{2}$ total area. It plays a vital role in the seeding of the track reconstruction algorithms and in the reconstruction of primary interactions and secondary decay vertices. It is surrounded by the strip tracker with 10 million read-out channels, corresponding to 200 m$^{2}$ total area. The tracker is operated in a high-occupancy and high-radiation environment established by particle collisions in the LHC. The performance of the silicon strip detector continues to be of high quality. The pixel detector that has been used in Run 1 and in the first half of Run 2 was, however, replaced with the so-called Phase-1 Upgrade detector. The new system is better suited to match the increased instantaneous luminosity the LHC would reach before 2023. It was built to operate at an instantaneous luminosity of around 2$\times$10$^{34}$cm$^{-2}$s$^{-1}$. The detector's new layout has an additional inner layer with respect to the previous one; it allows for more efficient tracking with smaller fake rate at higher event pile-up. The paper focuses on the first results obtained during the commissioning of the new detector. It also includes challenges faced during the first data taking to reach the optimal measurement efficiency. Details will be given on the performance at high occupancy with respect to observables such as data-rate, hit reconstruction efficiency, and resolution.

Commissioning of the test system for PS and 2S hybrids for the Phase-2 Upgrade of the CMS Outer Tracker

Hybrid designs and kick-off batch production experience for the CMS Phase-2 Upgrade

Prototyping and qualification of 2S modules for the CMS Outer Tracker upgrade at the HL-LHC

Quality Inspection Aspects of Hybrid Prototypes for the CMS Outer Tracker Upgrade at HL-LHC

Process Quality Control Strategy for the Phase-2 Upgrade of the CMS Outer Tracker and High Granularity Calorimeter

CMS Outer Tracker Phase-2 Upgrade on-module powering

Performance studies of the CMS Strip Tracker before installation

Beam Test Performance Studies of CMS Phase-2 Outer Tracker Module Prototypes

CMS HGCAL electronics vertical integration system tests

Performance verification of the CMS Phase-1 Upgrade Pixel detector

Results from the Commissioning Run of the CMS Silicon Strip Tracker

The Silicon Sensors for the High Granularity Calorimeter of CMS

Cms Resistive Plate Chamber Overview, from the Present System to the Upgrade Phase I

Demonstrator System Testing and Performance for the ATLAS ITk Pixel Detector for HL-LHC

The upgrade of the CMS muon system for the High Luminosity LHC

A monitoring and control test bench for assessing the upgraded low voltage power supplies for the ATLAS Tile Calorimeter Phase-II Upgrade front-end electronics

Subpixel Mapping and Test Beam Studies with a HV2FEI4v2 CMOS-Sensor-Hybrid Module for the ATLAS Inner Detector Upgrade

Design, production, burn-in and tests of the hybrid circuits of the Upstream Tracker at the LHCb detector

The CMS magnet test and cosmic challenge

Run 2 Upgrades to the CMS Level-1 Calorimeter Trigger