Research on compound amidohydroxysulfobetaine foamer for high-temperature and high-salinity clastic reservoirs

Longjie Li,Jijiang Ge,Zhenyu Zhang,Shiyu Xu,Xiyu Zhou,Pengfei Chen,Pengju Chu
DOI: https://doi.org/10.1016/j.colsurfa.2024.135120
IF: 5.518
2024-08-26
Colloids and Surfaces A Physicochemical and Engineering Aspects
Abstract:A high-quality foaming agent should exhibit excellent solubility in formation water and strong foaming ability, while also meeting the requirements of stability under high-temperature and high-salinity conditions, as well as low adsorption capacity. This study explores the potential of amidohydroxysulfobetaine surfactant as a foaming agent in sandstone reservoirs under specific reservoir conditions of 110 °C and 25.0×10 4 mg/L salinity. The findings indicate that compounding EHSB with a small amount of LHSB to form LA13 significantly reduces the Krafft point of EHSB. Furthermore, LA13 demonstrates outstanding solubility in 25.0×10 4 mg/L brine and exhibits an overall adsorption capacity on quartz sand surfaces lower than 0.6 mg/g when its concentration is below 1.0 wt%. Performance evaluation of bulk foam for LA31 at concentrations ranging from 0.05 wt% to 0.4 wt% suggests that using a foaming agent concentration of 0.05 wt% results in relatively low foaming volume and foam decay half-life; however, consistent foaming performance is observed across other concentrations, leading to highly stable foam due to the compound system's higher surface dilational modulus being the primary factor contributing to foam stability. Flow experiments reveal that the foam generated in cores with permeabilities of 46.5 mD, 185.5 mD, 632.0 mD, and 2005.3 mD exhibits a high resistance factor when the concentration of LA13 exceeds 0.1 wt%, while also demonstrating commendable gas-channeling regulation capability. Therefore, it is recommended to use LA13 as a foaming agent for field applications when its concentration surpasses 0.1 wt%. Additionally, comparing the mobility of foam formed by concentrations of 0.1 wt% and 0.2 wt% LA13 in cores with varying permeabilities shows that LA13 exhibits selective mobility regulation specifically in cores with permeabilities lower than 632.0 mD.
chemistry, physical
What problem does this paper attempt to address?