Abstract:Microwave electric fields are measured by using cold Rydberg atoms. We obtain spindle-shaped cold atomic clouds in a magneto-optical trap and then pump the cold atoms to quantum state 5S1/2, F = 2, mF = 2 by using an optical-pump laser. We obtain the Rydberg electromagnetic induction transparency (EIT) spectrum peak with narrow linewidth by the low temperature and small residual Doppler broadening. The results show that the typical EIT linewidth with 16 μK cold atoms is about 460 kHz which is 15 times narrower than that of 7 MHz obtained in the thermal vapor cell. The microwave electric field amplitude is measured by Autler-Townes splitting (EIT-AT splitting) in the cold atoms at frequencies of 9.2, 14.2 and 22.1 GHz, receptively. The results show that there is a good linear relationship between the EIT-AT splitting interval and the microwave electric field amplitude. The lower limit of the microwave electric field amplitude that can be measured in the linear region can reach as low as 222 μV/cm, which is about 22 times larger than the lower limit in the traditional thermal vapor cell about of 5 mV/cm. The improvement of the lower limit by EIT-AT splitting method is roughly proportional to the narrowing EIT line width by cold atom samples. This demonstrates that benefiting from the smaller residual Doppler effect and the narrower EIT linewidth in cold atoms, the cold atom system is more advantageous in the experimental measuring of the weak microwave electric field amplitude by using the EIT-AT splitting method. This is of great benefit to the absolute calibration of very weak microwave electric fields. Furthermore, the lower limit of the microwave electric field amplitude that can be measured is smaller than 1 μV/cm by using the change of transmittance of the prober laser at the EIT resonance, and the corresponding sensitivity can reach 1 μV·cm–1·Hz–1/2. These results demonstrate the advantages of cold atomic sample in microwave electric field measurement and its absolute calibration.

Influence of the size of the cubic atomic vapor cell on a Rydberg atomic microwave sensor

Effect of Rydberg-atom-based sensor performance on different Rydberg atom population at one atomic-vapor cell

The Realization of Disturbance-Reduction Small Vapor Cells for Broadband Microwave Detection With Rydberg Atoms

Large power dynamic range microwave electric field sensing in a vapor cell

Microwave electrometry with Rydberg atoms in a vapor cell using microwave amplitude modulation

Enhanced Microwave Electric Field Measurement With Cavity-Assisted Rydberg Electromagnetically Induced Transparency

Field Distortion and Optimization of a Vapor Cell in Rydberg Atom-Based Radio-Frequency Electric Field Measurement

Cavity-enhanced Rydberg atom microwave receiver

Magnetic-field-induced Splitting of Rydberg Electromagnetically Induced Transparency and Autler-Townes Spectra in 87rb Vapor Cell.

Sensitivity extension of atom-based amplitude-modulation microwave electrometry via high Rydberg states

Improvement of Microwave Electric Field Measurement Sensitivity via Multi-Carrier Modulation in Rydberg Atoms

Sensitivity Improvement and Determination of Rydberg Atom-Based Microwave Sensor

Vapor cell Rydberg atom electrometry with time-separated fields

Span Shift and Extension of Quantum Microwave Electrometry with Rydberg Atoms Dressed by an Auxiliary Microwave Field

Microwave electrometry with Rydberg atoms in a vapour cell using bright atomic resonances

Extending Bandwidth Sensitivity of Rydberg-atom-based Microwave Electrometry Using an Auxiliary Microwave Field

Continuously Expanding the Response Frequency of Rydberg Atom-Based Microwave Sensor by Using Quantum Mixer

Magnetic-field-induced splitting of Rydberg Electromagnetically Induced Transparency (EIT) and Autler-Townes (AT) spectra in $^{87}$Rb vapor cell

Measurement of Microwave Electric Field Based on Electromagnetically Induced Transparency by Using Cold Rydberg Atoms

Approaching the standard quantum limit of a Rydberg-atom microwave electrometer