Abstract:In the actual monitoring of deep hole displacement, the identification of slip surfaces is primarily based on abrupt changes observed in the inclinometric curve. In conventional identification methods, inclinometric curves exhibiting indications of sliding can be categorized into three types: B-type, D-type, and r-type. The position of the slip surface is typically determined by identifying the depth corresponding to the point of maximum displacement mutation. However, this method is sensitive to the interval of measurement points and the observation scale of the coordinate axes and suffers from unclear sliding surfaces and uncertain values. Based on the variation characteristics of these diagonal curves, we classified the landslide into three components: the sliding body, the sliding interval, and the immobile body. Moreover, three different generalization models were established to analyze the relationships between the curve form and the slip surface location based on different physical indicators such as displacement rate, relative displacement, and acceleration. The results show that the displacement rate curves of an r-type slope exhibit a clustering feature in the sliding interval, and by solving for the depth of discrete points within the step phase, it is possible to determine the location of the slip surface. On the other hand, D-type slopes have inflection points in the relative displacement curve located at the slip surface. The acceleration curves of B-type slopes exhibit clustering characteristics during the sliding interval, while the scattered acceleration data demonstrate wandering characteristics. Consequently, the slip surface location can be revealed by solving the depth corresponding to the maximum acceleration with cubic spline interpolation. The approach proposed in this paper was applied to the monitoring data of a landslide in Yunnan Province, China. The results indicate that our approach can accurately identify the slip surface location and enable computability of its position, thereby enhancing applicability and reliability of the deep-hole displacement monitoring data.

Identifying and analyzing the distribution of sliding surfaces in rock slopes using total displacement contour maps

A New Semi-Deterministic Block Theory Method with Digital Photogrammetry for Stability Analysis of a High Rock Slope in China

Identification of arbitrarily shaped critical 3D failure surface of a slope based on the sliding direction

Development of a probabilistic block theory analysis procedure and its application to a rock slope at a hydropower station in China

A solution for evaluating stability and sliding direction of 3D earthquake landslides

A new method for quantitative identification of potential landslide

Identification of the Potential Critical Slip Surface for Fractured Rock Slope Using the Floyd Algorithm

A statistics-based discrete element modeling method coupled with the strength reduction method for the stability analysis of jointed rock slopes

Probabilistic Assessment of Seismic Stability of a Rock Slope by Combining the Simulation of Stochastic Ground Motion with Permanent Displacement Analysis

Integration of Automatic Discontinuity Identification and Multi-Scale Hierarchical Modeling for Stability Analysis of Highly-Jointed Rock Slopes

A modified solution for evaluating the sliding direction and stability of 3D slopes

Automatic discontinuity identification and quantitative monitoring of unstable blocks using terrestrial laser scanning in large landslide during emergency disposal

A Method for Automatic Assessment of Rockfall Susceptibility Based on High-Resolution Point Clouds

Stability Analysis of Seismic Slope Based on Relative Residual Displacement Increment Method

Dynamic stability analysis of jointed rock slopes using the combined finite-discrete element method (FDEM)

Application of 3D-DDA Integrated with Unmanned Aerial Vehicle–laser Scanner (UAV-LS) Photogrammetry for Stability Analysis of a Blocky Rock Mass Slope

Probabilistic seismic slope stability analysis using swarm response surfaces and rotational Newmark sliding model with primary sliding direction

A New Method for Automatic Extraction and Analysis of Discontinuities Based on TIN on Rock Mass Surfaces

Method for determining the position of landslide slip-surface with a typical inclinometric curves

A novel framework for ascertaining the safety factor and critical slip surface of 3D slopes reinforced with piles

Evaluation of the possible slip surface of a highly heterogeneous rock slope using dynamic reduction method