Abstract:This work aims to elucidate the hot deformation behavior and microstructure evolution of a non-equimolar TiZrHf-rich refractory high-entropy alloy (RHEA) with a composition of Ti2ZrHfV0.5Ta0.2 (at. %). The as-cast Ti2ZrHfV0.5Ta0.2 alloy composed solely of a body-centered cubic phase showed superior tensile mechanical properties with a yield strength of 865 MPa and a total elongation of 22.5%. The uniaxial compression tests were performed at temperatures ranging from 900 to 1100 °C and strain rates varying from 10−3 to 10−1 s−1. The relation among the flow stress, deformation temperature, and strain rate was represented by the Arrhenius-type constitutive equations. The calculations show a comparatively low apparent activation energy of 144–119 kJ/mol over the entire range of strains, revealing a noticeable contradiction between the concentration of group IV elements (Ti, Zr, Hf) and the high-temperature strength. The excessive addition of Group IV elements tends to deteriorate the high-temperature strength due to the relatively low melting points and self-diffusion activation energies of Group IV elements. The misorientation analysis based on electron back-scattered diffraction indicated that the dynamic recrystallization mechanism depends strongly on the thermo-mechanical processing conditions. A low deformation temperature and high strain rate results in an abnormal discontinuous dynamic recrystallization mechanism. Additionally, the dominant role played by the edge dislocation in RHEAs during deformation is supposed to be the reason for the abnormal discontinuous dynamic recrystallization mechanism. A series of stress drops were observed under low deformation temperatures and high strain rates. Based on an interrupted hot-compression experiment and a strain aging experiment, the stress drop can be attributed to the unlocking of dislocations pinned by the Cottrell atmosphere or short-range ordering.

A novel stress-induced martensitic transformation in a single-phase refractory high-entropy alloy

Atomic Deformation Mechanism and Interface Toughening in Metastable High Entropy Alloy

Lattice Distortion in a Strong and Ductile Refractory High-Entropy Alloy

Lattice‐Distortion‐Enhanced Yield Strength in a Refractory High‐Entropy Alloy

Remarkable ductility in metastable refractory high entropy alloys via BCC-FCC/α′′ martensitic transformations

Molecular dynamics simulation of phase transition and crack propagation in metastable high entropy alloy

Molecular dynamics simulations for nanoindentation response of metastable high entropy alloy

Hexagonal Closed-Packed Precipitation Enhancement in a NbTiHfZr Refractory High-Entropy Alloy

Atomic mechanism of cyclic healing effect in dual-phase metastable high entropy alloy

Microstructures and mechanical properties of TiZrHfNbTaWx refractory high entropy alloys

Interstitial atoms enable joint twinning and transformation induced plasticity in strong and ductile high-entropy alloys

Phase stability, local chemical disorder and its effect on the mechanical properties of refractory high-entropy alloys

Effects of Ti content on the tensile ductility, lattice distortion and mechanical properties of VNbTaTi x refractory high-entropy alloys

Hot deformation behavior and microstructure evolution of non-equimolar Ti2ZrHfV0.5Ta0.2 refractory high-entropy alloy

Micromechanical origin for the wide range of strength-ductility trade-off in metastable high entropy alloys†

Unexpected sluggish martensitic transformation in a strong and super-ductile high-entropy alloy of ultralow stacking fault energy

FCC-BCC Phase Transformation Induced Simultaneous Enhancement of Tensile Strength and Ductility at High Strain Rate in High-Entropy Alloy

Toughening FeMn-based High-Entropy Alloys Via Retarding Phase Transformation

Natural-mixing guided design of refractory high-entropy alloys with as-cast tensile ductility

Exceptionally high strain-hardening and ductility due to transformation induced plasticity effect in Ti-rich high-entropy alloys

Phase evolution and mechanical properties of low-activation refractory high-entropy alloy Ti1.5ZrV0.5Ta0.5