Abstract:Hertzian contact of a rigid sphere and a highly deformable soft solid is investigated using integrated photoelasticity. The experiments are performed by pressing a styrene sphere of 15 mm diameter against a 44 × 44 × 47 mm 3 cuboid made of 5% wt. gelatin, inside a circular polariscope, and with a range of forces. The emerging light rays are processed by considering that the retardation of each ray carries the cumulative effect of traversing the contact-induced axisymmetric stress field. Then, assuming Hertz's theory is valid, the retardation is analytically calculated for each ray and compared to the experimental one. Furthermore, a finite element model of the process introduces the effect of finite displacements and strains. Beyond the qualitative comparison of the retardation fields, the experimental, theoretical, and numerical results are quantitatively compared in terms of the maximum equivalent stress, surface displacement, and contact radius dimensions. A favorable agreement is found at lower force levels, where the assumptions of Hertz theory hold, whereas deviations are observed at higher force levels. A major discovery of this work is that, at the maximum equivalent stress location, all three components of principal stress can be determined experimentally and show satisfactory agreement with theoretical and numerical ones in our measurement range. This provides valuable insight into Hertzian contact problems since the maximum equivalent stress controls the initiation of plastic deformation or failure. The measured displacement and contact radii also reasonably agree with the theoretical and numerical ones. Finally, the limitations that arise due to the linearization of this problem are explored.

An Engineering Approach to Hertzian Contact Elasticity—Part I

Analysis of elliptical Hertzian contacts

Hertzian contact of orthotropic materials

Theoretical Formula for Calculation of Line-contact Elastic Contact Deformation

An effective method for calculating elasto-plastic contact pressure and contact patch size under elliptical, circular and line contact conditions

On Elastic Line Contact

Axisymmetric Hertzian Contact Problem Accounting for Surface Tension and Strain Gradient Elasticity

Some New Results in Rolling Contact

Lubrication Of Nonconformal Contacts

Hertzian Contact-Stress Deformation Coefficients

Elastic response of a cylinder loaded by a Hertzian contact pressure and maintained in equilibrium by its inertia

Contact Behavior Between Rail and Elastic Foundation

A Finite Element Study of an Elasto-Plastic Disk or Cylindrical Contact Against a Rigid Flat in Plane Stress with Bilinear Hardening

Analysis and Convenient Formulas for Elasto-Plastic Contacts of Nominally Flat Surfaces: Average Gap, Contact Area Ratio, and Plastically Deformed Volume

Efficient Numerical Modeling of Hertzian Line Contact for Material With Inhomogeneities

A Simplified Numerical Elastic-Plastic Contact Model for Rough Surfaces

Two-dimensional Hertzian contact problem with surface tension

Generalisation of the linear theory of rolling contact to a single double-elliptic contact region and its application to solve non-Hertzian contact problems using extended FASTSIM

On Boussinesq's Problem for a Power-Law Graded Elastic Half-Space on Elliptical and General Contact Domains

An Investigation Of Hertzian Contact In Soft Materials Using Photoelastic Tomography