Abstract:Transactions of the Institute of Measurement and Control, Ahead of Print. Accurate dynamic parameters are essential for precise control of model-based manipulators. Due to the direct connection between the joint axis and the motor rotor of the direct drive manipulator, using additional joints would increase the disturbance of the system, leading to substantial trajectory tracking errors, which could potentially harm the manipulator if the tracking error exceeds the limited position of joints, and it also curtails the comprehensive parameter excitation and affects the identification accuracy. Restricting joint movement to a narrow area can prevent this injury, but it also curtails the comprehensive parameter excitation and affects the identification accuracy. To address these challenges, this paper presents a novel method for identifying dynamic parameters of multiple degree-of-freedom (DOF) series direct drive manipulators. Specifically, an open-loop gravity torque compensation strategy with spatial geometric characteristics is introduced to ensure secure operation during manipulator identification processes. Meanwhile, an improved model reference adaptive identification (MRAI) method is presented to estimate the nominal inertia quickly and accurately. Finally, a disturbance observer (DOB) based on minimum model perturbation bound is proposed to compensate for significant variations in model disturbances, enabling stable and precise tracking of planned exciting trajectories. This proves advantageous for fully exciting dynamic parameters and improving identification accuracy. Simulation experiments demonstrate that the tracking error of each joint's exciting trajectory is within 0.07 radians, and the maximum absolute error of identifying dynamic parameters is 0.099169409, which verifies the feasibility and effectiveness of the proposed method.

Dynamic model of a joint of the manipulator and LQG control optimized with GA and PSO metaheuristics

Dynamic Modeling and Analysis for Coupling Processing 6-DOF 3 P3 R Manipulator

Torque Limitation Control of Industrial Manipulators Based on General Weighted Least Norm Method

GA-based Dynamic Manipulability Optimization of a 2-DOF Planar Parallel Manipulator

Dynamic Model and Inverse Kinematic Identification of a 3-DOF Manipulator Using RLSPSO

Position-Based Visual Servoing Control for Multi-Joint Hydraulic Manipulator

Modeling of PID controlled 3DOF robotic manipulator using Lyapunov function for enhancing trajectory tracking and robustness exploiting Golden Jackal algorithm

A model-based PID-like motion control method for flexible-joint manipulator with harmonic drives

Optimized Power Rate Sliding Mode Control for a Robot Manipulator Using Genetic Algorithms

Takagi-Sugeno Fuzzy Modeling and Control for Effective Robotic Manipulator Motion

Decoupled Dynamic Model and Control of Flexible Space Manipulator

Enhanced Equation Discovery of 3-DoF Robotic Manipulator Dynamics Using LASSO Model Selection Criteria With Variable Segregation Algorithm

A novel dynamic parameter identification method for the multi-degrees-of-freedom series direct drive manipulator

Modeling and Active Vibration Control of an Intelligent Flexible Manipulator System

Optimal Design of a Five-Bar Planar Manipulator and Its Controller by Using Different Algorithms for Minimum Shaking Forces and Moments for the Largest Trajectory in a Usable Workspace

Modeling and Multi-objective Optimization of a Kind of Teaching Manipulator

Modeling and Simulation of a Point to Point Spherical Articulated Manipulator using Optimal Control

Self-Tuning Control of Manipulator Positioning Based on Fuzzy PID and PSO Algorithm

Model-based Control for 6-DOF Parallel Manipulator

A new control method of flexible-joint manipulator with harmonic drive

Dynamics Analysis and Control of a Two-Link Manipulator