Abstract:It is of great significance to study the mechanical properties of rocks with different saturations for safe and efficient development of geotechnical engineering in low-temperature environments, such as open-pit mining and tunnel excavation in winter in cold areas, and etc. In this paper, the LT-SHPB test system was used to carry out impact loading tests for sandstones with various saturations at − 20 °C environment. SEM was used to observe the cross-sectional characteristics of the specimens. The distributions of fragments were obtained by screening after impact failure. The energy dissipation model was established during the failure process. The research results indicated that the failure strength, elastic modulus, and peak strain of sandstones showed significant strain rate strengthening. Under the fixed strain rate, as the increase of the water content, the failure strength and elastic modulus and the sensitivity increased first and then decreased, while the peak strain showed the opposite change characteristics. 75% saturation was the turning point of the change. The sandstones under saturated water content exhibited remarkable ductile failure characteristics, while the brittle failure dominated in other conditions. The fundamental reason for this change was the difference between the freezing and frost heave effects of water-bearing specimens under low temperature conditions. The change characteristics of the macroscopic damage degree of sandstones with the strain rate and water content were basically the same as the characteristics of mechanical properties. The higher the internal density, the more the dissipated energy and surface specific energy for the whole failure of the specimen. The energy dissipation difference could directly change the macroscopic failure characteristics.

Dynamic mechanical properties and energy dissipation of frozen weakly cemented red sandstone under high strain rate loading

Energy evolution and macro-micro failure mechanisms of frozen weakly cemented sandstone under uniaxial cyclic loading and unloading

Study on dynamic mechanical response characteristics and fracture energy dissipation mechanism of sandstones with different saturations under real-time low temperature

An experimental study on the influence of ice saturation and sub-zero temperatures on the dynamic mechanical properties of sandstones

Dynamic Compressive Test of Saturated Sandstones Under Ambient Sub-Zero Temperature

Dynamic Mechanical Properties of Dry and Water-Saturated Siltstones Under Sub-Zero Temperatures

Study on the Influence of Temperature and Water Content on the Static Mechanical Properties of Sandstone

Dynamic Mechanical Response and Dissipated Energy Analysis of Sandstone under Freeze-Thaw Cycles

Nonlinear Dynamic Constitutive Model of Frozen Sandstone Based on Weibull Distribution

Experimental Investigation on Fracture Behavior and Mechanical Properties of Red Sandstone Subjected to Freeze–Thaw Cycles

Critical slowing down features of acoustic emission signals for predicting the failure of black sandstone under different freezing temperatures

Study on Long-Term Dynamic Mechanical Properties and Degradation Law of Sandstone under Freeze-Thaw Cycle

Creep properties and Model of Fractured Sandstone Under Freezing Environment

Experimental Study on Dynamic Compression Characteristics of Red Sandstone under Wetting-Drying Cycles

Effects of ice content on compression characteristics of frozen sandstone by in-situ NMR technology

Energy evolution and crack development characteristics of sandstone under freeze-thaw cycles by digital image correlation

Study on the mechanical properties of saturated red sandstone under freeze–thaw conditions

Dynamic Splitting Experimental Study on Sandstone at Actual High Temperatures under Different Loading Rates

Energy evolution characteristics and mechanical properties of freeze-thawed red sandstone under repeat impact loading

Linking the mechanical properties of frozen sandstone to phase composition of pore water measured by LF-NMR at subzero temperatures

Research on Dynamic Mechanical Properties of Sandstone at High Temperature