Abstract:In response to the call for environment protection, more and more researches have been finding new alternative refrigerants which are of zero Ozone depleting potential (ODP), low global warming potential (GWP) and will be efficient, inflammable, and nontoxic to replace the HCFCs and HFCs refrigerants. Non-azeotropic mixtures of suitable fluids are becoming the important candidates of that search race. In this paper, the flow and heat transfer performance of CO2-DME (dimethyl ether) mixture refrigerants at 8.0 MPa in a horizontal tube was numerically investigated. In particular, this work has been focused upon the laminar heat transfer characteristics of CO2-DME mixture refrigerant flow with Reynolds number ranging from 180 to 1800 and the mass fraction of DME ranging from 21% to 39%. The results show that the heat transfer performance of the mixture fluid can be improved when the mass fraction of DME increases to 30%. Considering both the best heat transfer performance and the safety, the optimum component of CO2-DME (70/30, mass%) has been found in this study. And the mechanisms that are responsible for the heat transfer enhancement are obtained and they are: (1) The temperature gradient of CO2-DME mixture fluid with high mass fraction of DME is larger than that of CO2-DME mixture fluid with low mass fraction of DME; in addition, the temperature gradient increases with the mass fraction of DME; (2) The increase of thermal conductivity for CO2-DME mixtures can enhance the heat transfer performance to a large extent. (3) The self-acceleration characteristic of the supercritical mixture fluid is also beneficial to the heat transfer enhancement. Furthermore, it is found that the heat transfer performance of the mixture fluid can also be improved with Reynolds number. The viscous boundary layer of the fluid becomes thinner when the Reynolds number increases, which leads to an enhancement in heat transfer. In addition, at high Reynolds number, the flow is tend to be turbulent, which is beneficial to the heat transfer performance of mixture fluid. With regard to the flow characteristic of mixtures, first the flowing changes depend on the temperature and the density of fluid to a large extent-the high value of velocity can occur when the fluid has a high temperature and a low density. And secondly, the supercritical CO2-DME mixtures speed up along the tube and make themselves different with water flow. These results of this study have significant implications for the design of high-performance heat exchangers, using CO2-DME mixture as the working fluid.

Experimental Heat Transfer Coefficients for Zeotropic Mixture Condensation of Hexamethyldisiloxane/Octamethyltrisiloxane and Ethanol/Hexamethyldisiloxane

Experimental and analytical investigation on flow condensation heat transfer of zeotropic mixtures of tetrafluoromethane/ethane

Contribution of the Hydroxyl Group on Interfacial Heat Conduction of Monohydric Alcohols: A Molecular Dynamics Study

Investigation on the Vapor–Liquid Equilibrium for the Ternary Mixture HFC-32 + HFC-125 + HFC-161 at Temperatures from 265.15 K to 303.15 K

Experimental research on non-azeotropic immiscible binary mixed vapors condensation mode and heat mass transfer characteristics under natural convection

A Numerical Study on Heat Transfer Characteristics of CO2-DME Mixture Fluid

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Measurement and modeling of liquid thermal conductivity of linear siloxanes: Octamethyltrisiloxane (MDM) and Hexamethyldisiloxane (MM)

Vapor−Liquid Equilibrium Data for the Binary Mixture Difluoroethane (HFC-32) + Pentafluoroethane (HFC-125) of an Alternative Refrigerant

Effect of Non-Condensable Gas Mass Fraction on Condensation Heat Transfer for Water-Ethanol Vapor Mixture

Thermodynamic analysis of novel mixtures including siloxanes and cyclic hydrocarbons for high-temperature heat pumps

Condensation in Horizontal Smooth Tubes: A New Heat Transfer Model for Heat Exchanger Design

SIMULATION OF HEAT TRANSFER IN THE CONTACT LINE REGION OF PURE PENTANE AND PENTANE/HEXANE MIXTURE IN A CLOSED MICROCAVITY

Experimental study on condensation flow patterns and heat transfer characteristics of non-azeotropic and immiscible binary mixed vapors

Experimental Isobaric Heat Capacity of Liquid HFC-32+HFO-1234ze(E) Mixture and Extension of a Predictive Corresponding State Equation to HFC Mixtures

Experimental Speed of Sound in Two Emerging Mixture Working Fluids of [r1234ze(z) + R1233zd(E)] and [r1234ze(z) + Isobutane]

Determination of Mass Transfer Coefficient for Condensation Simulation

Condensation heat and mass transfer of steam with non-condensable gases outside a horizontal tube under free convection

Theoretical Analysis for the Condensation Heat Transfer of a Binary Vapor Mixture under the Thermal Equilibrium Condition.

Experimental Investigation on Heat Transfer of R1234ze and R22 During Condensation in Minichannels

Investigation on thermal conductivity of decamethylcyclopentasiloxane (D5) and decamethyltetrasiloxane (MD2M) in the liquid phase