Abstract:Mechanical signals drive neural cell growth and migration during development and regeneration. Although most cells migrate towards stiffer substrates, neurons can migrate in the opposite direction. We hypothesized that neural growth cones, known to affect stiffness sensing, are stiffness sensors as well, and tested this hypothesis via a mathematical model. The model integrates interactions between axons, growth cones and substrate through a two-dimensional molecular clutch model of filopodial dynamics and a viscoelastic model of active axon contraction. The modeling results predict that different types of neurons should have distinct mechanosensing behaviors, with dorsal root ganglion cells behaving differently than hippocampal neurons. Also, substrate stiffness can guide growth cone motion through altering the traction force generated in the growth cone. The model provides the first explanation of how stiffness can be sensed and provides mechanistic insight into how axon-growth cone-substrate interactions drive neural regeneration and repair. Since existing models failed to address the interactions between axons, growth cones and ECM stiffness in neural mechanosensing, we constructed a mathematical model of growth cone based on the molecular clutch framework of Odde et al., which treats focal adhesion proteins and the substratum as linear springs loaded by a cytoskeletal tension, to investigate how substrate stiffness affects growth cone dynamics and axonal retraction. Briefly, a group of i filopodia, each modeled as a single molecular clutch module, are attached to an axon that is modeled as a contractile element in parallel with a standard linear viscoelastic solid. Each molecular clutch module contains n(i) adhesion clutches (linear springs of stiffness k(i)) and n(i) corresponding substrate clutches (linear springs with stiffness E-i). Substrate clutches are distributed randomly, and have values E-1 <= E-i <= E-2 that vary linearly with position as a first order approximation to the spatially graded, nonlinear mechanical properties of ECM. Adhesion clutches bind to substrate clutches with a rate of k(on), forming a force transmission pathway from intracellular cytoskeleton, where contraction arises from inward actin flow, to the extracellular substrate. The unbinding rate of k(off,i) varies with the force F-i in the connected clutch according to the Bell model. We first studied the different behaviors between neurons from dorsal root ganglion and hippocampus respectively and found that the expression of adhesion proteins on growth cone is vital for the generation of traction force. Since traction force is determinant to the axon dynamic processes including elongation and retraction, the expression of adhesion proteins thus plays a vital role in neuron mechanical behaviors. Then we tried to predict how the axon responds to substrate with different stiffness by combining the growth cone model with a viscoelastic contractile axon body model. The combined model illustrated how the contraction of myosin molecular motors decreases as the axon deformation rate goes down. The results further showed that low motor contraction can cause the axon retraction on high-stiffness substrate while much higher contraction force is needed for the axon retraction on low-stiffness substrate. The predictions conform to previous experimental observations in the literature and indicate that the increase of motor contraction leads to the axon retraction on the substrate with the same stiffness, providing the possible reasons that neurons usually migrate towards the low-stiffness area instead of durotaxis seen in other cell types. Altogether, our model results suggest that growth cone filopodial dynamics, including dynamics of turning, enlargement and contraction, can explain how substrate stiffness affects neuronal mechanosensing, and shed light on how the nervous system might develop to distinguish and reach target tissues and cells by mechanosensing.

Temperature response of the neuronal cytoskeleton mapped via atomic force and fluorescence microscopy

Elasticity Maps of Living Neurons Measured by Combined Fluorescence and Atomic Force Microscopy

Neurite branch retraction is caused by a threshold-dependent mechanical impact.

Temperature-Dependent Conformational Properties of Human Neuronal Calcium Sensor-1 Protein Revealed by All-Atom Simulations.

Autophagy, the Ubiquitin proteasome system, and the MAPK pathway control the temperature dependence of synaptic growth.

Physical limits to biomechanical sensing

The role of temperature in the rigidity-controlled fracture of elastic networks

Nonthermal driving forces in cells revealed by nonequilibrium fluctuations

Neuronal Activity and Adenylyl Cyclase in Environment-Dependent Plasticity of Axonal Outgrowth in Drosophila

Thermosensory Spiking Activity of Proteinoid Microspheres Cross-Linked by Actin Filaments

Mapping stress inside living cells by atomic force microscopy in response to environmental stimuli

Kinetics of Mechanoresponse in the Mammalian Actin Cytoskeleton

Deformation Microscopy for Dynamic Intracellular and Intranuclear Mapping of Mechanics with High Spatiotemporal Resolution

Reliable and efficient processing of sensory information at body temperature by rodent cortical neurons

A Mechanical Model of Neuron Axons Considering Extracellular Matrix Stiffness

Effect of F-actin and Microtubules on Cellular Mechanical Behavior Studied Using Atomic Force Microscope and an Image Recognition-Based Cytoskeleton Quantification Approach

Cellular Thermal Biology Using Fluorescent Nanothermometers

Structural and mechanical remodeling of the cytoskeleton maintains tensional homeostasis in 3D microtissues under acute dynamic stretch

Dynamic biophysical responses of neuronal cell nuclei and cytoskeletal structure following high impulse loading

Viscoelastic mapping of mouse brain tissue: relation to structure and age

Myelination dictates axonal viscoelasticity