Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

State Feedback Control for Adjusting the Dynamic Behavior of a Piezoactuated Bimorph Atomic Force Microscopy Probe

Creep and Hysteresis Compensation for Nanomanipulation Using Atomic Force Microscope

Design and Control of a Piezoelectric Ceramic-actuated and Flexure Hinge-based Micromanipulator

Suppressing nano-scale stick-slip motion by feedback

Automated Nanomanipulation with Afm by Using L-1 Adaptive Controller

Atomic Force Microscope-Based Nanomanipulation with Drift Compensation

Nonlinear Control of Hybrid Electrostrictive/Piezoelectric Polymeric Structures: Theory and Experiment

Precision Control of A Piezo-Actuate System Using Fuzzy Sliding-Mode Control with Feedforward Predictor-Based Compensation

Feedforward and Feedback Control for Piezoelectric-Actuated Systems Using Inverse Prandtl-Ishlinskii Model and Particle Swarm Optimization

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Regulation of a microcantilever response by force feedback

Adaptive critic neural network force controller for atomic force microscope-based nanomanipulation

Modeling and Simo Controlling of Piezoceramic Hysteresis

Flexoelectric Control of Beams with Atomic Force Microscope Probe Excitation

Automatic Drift Compensation Using Phase Correlation Method for Nanomanipulation

Model-Free Adaptive Sensing and Control for a Piezoelectrically Actuated System

Enhanced feedback performance in off-resonance AFM modes through pulse train sampling

Feedback linearization and equivalent-disturbance compensation control strategy for piezoelectric stage

Output Feedback Control of a Piezoelectric Robotic Manipulator During the Characterization of an Object Exhibiting Nonlinear Viscoelastic Deformation

Reducing stick-slip motion in one-dimensional nano manipulation by real-time feedback control