Abstract:Distinct from the conventional double‐balanced mixer topology, a resonator was employed at the emitter of the transconductance stage, which enables the utilization of transconductance stage as an active balun, allowing for direct feeding of the single‐ended input without sacrificing the advantageous of the double‐balanced topology. The integration of the resonator reduces the amplitude and phase errors within the active balun segment, thereby enhancing port‐to‐port isolation. The area occupied by the resonator is approximately 1.7 times smaller than that of an RF transformer balun typically employed in conventional double‐balanced topologies. This paper introduces a downconverter mixer employing a modified double‐balanced Gilbert‐cell topology, designed using IHP's 0.13‐μ m SiGe BiCMOS technology. Distinct from the conventional topology, a resonator was employed at the emitter of the transconductance stage, which enables the utilization of transconductance stage as an active balun, allowing for direct feeding of the single‐ended input without sacrificing the advantageous of the double‐balanced topology. The integration of the resonator reduces the amplitude and phase errors within the active balun segment, thereby enhancing port‐to‐port isolation. The area occupied by the resonator is approximately 1.7 times smaller than that of an RF transformer balun typically employed in conventional double‐balanced topologies. The LO and IF differential signals are converted to single‐ended ones through transformer baluns for measurement purposes. The frequencies of operation for RF, LO, and IF are 24–30, 18–24, and 6 GHz, respectively. The conversion loss is 7.7 dB at 26 GHz, with port‐to‐port isolations exceeding 35 dB. The input 1‐dB compression point is 5.7 dBm, while the circuit consumes 65‐mW power from a 3.3‐V voltage supply. Excluding the pads, the active area of the design spans 1 mm2.

A novel frequency down-converter design at X-band for LEO satellite ground station using single conversion

A new X‐band frequency up‐converter design for LEO satellite ground station utilizing a single superheterodyne

A ${\hbox{70}}{\hbox{–}} {\Hbox{78-}}{\Hbox{ghz}}$ Integrated CMOS Frequency Synthesizer for $W$-Band Satellite Communications

A ${\hbox{70}}{\hbox{–}} {\Hbox{78-}}{\Hbox{ghz}}$ Integrated CMOS Frequency Synthesizer for $W$ -Band Satellite Communications

A Novel Reconfigurable Ultra-Broadband Millimeter-Wave Photonic Harmonic Down-Converter

Photonic Down-Conversion and Linearisation with Tunable IF Bandwidth and Improved Spurious-Free Dynamic Range

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

An integrated frequency synthesizer for 81–86GHz satellite communications in 65nm CMOS

A Novel Architecture of Satellite‐ground Communication System at W‐band Based on RF Transparent Demodulation Technique

Four-channel broadband compact multi-antenna GNSS downconverter for high-reliability navigation

Dual-Conversion Microwave Down Converter for Nanosatellite Electronic Warfare Systems

A Highly-Integrated Ka-Band Direct Up-Conversion Transmitter for Satellite Communication in 65nm CMOS

A Low Cost And High Performance Design Of X-Band Short Range Doppler Radar Transceiver

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

All‐optical Frequency Converter Based on Fiber Four‐wave Mixing for Bidirectional Radio‐over‐fiber Systems

Design and Realization of an X Band Monopulse Feed Antenna for Low Earth Orbit (LEO) Satellite Ground Station

An 18–28 GHz dual-mode down-converter IC for 5G applications

A 24–30‐GHz Modified Gilbert‐Cell Downconverter With High Linearity and Isolation

A 30-60 GHz Broadband Low LO-Drive Down-Conversion Mixer with Active IF Balun in 65 nm CMOS Technology

ADS optimization design of GPS RF front-end circuit with auto gain control