Abstract:Environmental context Heavy metal pollution is a worldwide environmental concern, and the risk depends not only on their total concentration, but also on their chemical speciation. Based on state-of-the-art geochemical modelling, we pinpoint the heavy metal pools approached by the widely used sequential extraction method. The finding of this paper can help users of sequential extraction methods to better interpret their results. Abstract In this study, the metal (Cd, Cu, Zn and Pb) fractionation determined by selective sequential extraction (SSE) was compared with metal speciation calculated using a geochemical model, the Multi-Surface Model (MSM). In addition, the sources of Cd, Cu and Zn extracted in the SSE were identified with the help of the modelling. The results showed that the SSE-based Cd fractionation contradicted the modelled results, with the organic-bound Cd as respectively the least and the most important species. This contradiction was explained by the model and was attributed to the weak specific adsorption of Cd to organic matter; For Cu, a good agreement was found between SSE and model fractionation, both recognising organic-bound Cu as the most dominant fraction. The high affinity of organic matter for Cu reduced the degree of Cu extracted in steps preceding the oxidation step. The SSE measured a larger exchangeable Zn fraction than the model predicted, which could be explained by Zn extracted from organic-bound, oxide-bound forms, and certain rapidly dissolvable Zn-minerals if present. Zinc in the micropores of minerals was probably not extracted in 0.43M HNO3, thus was not included in the modelling for adsorption calculation, which could explain to a certain extent the larger amount of oxide-bound Zn determined in the SSE than calculated in the model. The modelling results for Pb were less reliable than for other metals because of a poor accuracy of Pb concentration in solution predicted. The findings of this paper can help users of the sequential extraction methods to better interpret their results.

Sequential extraction procedure for the speciation of particulate trace metals

A New Sequential Extraction Procedure for the Speciation of Particulate Trace Elements in River Sediments

Evaluation of a sequential extraction procedure for the speciation of heavy metals in sediments

An alternative sequential extraction scheme for the determination of trace elements in ferrihydrite rich sediments

Speciation Analysis of the River Sediment ( Ⅱ )--tessier Sequential Chemical Extraction Procedures

Comparison of three sequential extraction protocols for the fractionation of potentially toxic metals in coastal sediments

Interpretation of heavy metal speciation in sequential extraction using geochemical modelling

Assessment of the Tessier and BCR sequential extraction procedures for elemental partitioning of Ca, Fe, Mn, Al, and Ti and their application to surface sediments from Chinese continental shelf

Comparison of Analytical Techniques for Dynamic Trace Metal Speciation in Natural Freshwaters

Dispersive Liquid–Liquid Microextraction and Micro-Solid Phase Extraction for the Rapid Determination of Metals in Food and Environmental Waters

Simultaneous Enrichment of Inorganic and Organic Species of Lead and Mercury in Pg L−1 Levels by Solid Phase Extraction Online Combined with High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry

Simultaneous Measurements of Cr, Cd, Hg and Pb Species in Ng L-1 Levels by Interfacing High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry.

Is there future of sequential chemical extraction for speciation analysis of metal(loid)s in plants?

Development of a standardized sequential extraction protocol for simultaneous extraction of multiple actinide elements

Sequential Speciation Analysis of Heavy Metals in Drinking Water Pipe Scales by Mass Spectrometry

Conventional, microwave, and ultrasound sequential extractions for the fractionation of metals in sediments within the Petrochemical Industry, Serbia

Geochemical speciation of trace metals in sediments of the northern Nile Delta Lake by sequential extraction technique

Optimization of a sequential extraction procedure for trace elements in Arctic PM10

Sequential speciation analysis of heavy metals on suspended particulate matter in water using electrochemical mass spectrometry

Sequential chemical extraction and mineralogical bonding of metals from Styrian soils

Elemental speciation studies--new directions for trace metal analysis