Human radiological safety assessment for petawatt laser-driven ion acceleration experiments in CLAPA-T

Xiaopeng Zhang,Jiarui Zhao,Shengxuan Xu,Xun Chen,Ying Gao,Shiyou Chen,Kun Zhu,Xueqing Yan,Wenjun Ma
DOI: https://doi.org/10.1063/5.0172687
IF: 6.089
2024-04-12
Matter and Radiation at Extremes
Abstract:The newly built Compact Laser Plasma Accelerator–Therapy facility at Peking University will deliver 60 J/1 Hz laser pulses with 30 fs duration. Driven by this petawatt laser facility, proton beams with energy up to 200 MeV are expected to be generated for tumor therapy. During high-repetition operation, both prompt radiation and residual radiation may cause safety problems. Therefore, human radiological safety assessment before commissioning is essential. In this paper, we simulate both prompt and residual radiation using the Geant4 and FLUKA Monte Carlo codes with reasonable proton and as-produced electron beam parameters. We find that the prompt radiation can be shielded well by the concrete wall of the experimental hall, but the risk from residual radiation is nonnegligible and necessitates adequate radiation cooling. On the basis of the simulation results, we discuss the constraints imposed by radiation safety considerations on the annual working time, and we propose radiation cooling strategies for different shooting modes.
physics, multidisciplinary
What problem does this paper attempt to address?
This paper aims to solve the problem of human radiation safety assessment in the petawatt - laser - driven ion acceleration experiment in the newly - established Compact Laser - Plasma Accelerator - Therapy (CLAPA - T) facility at Peking University. Specifically, this study focuses on the potential safety issues caused by the prompt radiation and residual radiation generated by the interaction between the laser and matter during high - repetition - frequency operation. By using Geant4 and FLUKA Monte Carlo codes to simulate these two types of radiation, and based on the simulation results, the radiation cooling strategies under different shooting modes are discussed to ensure the safety and effectiveness of the experiment. The main contributions of the paper are as follows: 1. **Simulation of Prompt and Residual Radiation**: Using advanced simulation tools (Geant4 and FLUKA), a detailed simulation analysis of the prompt radiation and residual radiation generated in the laser - driven proton acceleration experiment was carried out. These simulations take into account reasonable proton and secondary electron beam parameters. 2. **Effectiveness Evaluation of Radiation Shielding**: The study shows that the concrete walls of the experimental hall can effectively shield the prompt radiation, but the risk of residual radiation cannot be ignored and sufficient radiation cooling measures are required. 3. **Relationship between Working Hours and Radiation Safety**: According to the simulation results, the paper discusses the limitations of annual working hours due to radiation safety considerations and proposes radiation cooling strategies applicable to different shooting modes. 4. **Experimental Design and Safety Recommendations**: The paper also proposes specific radiation safety strategies, including the need for a longer radiation cooling time in the continuous shooting mode, and matters that require special attention in the high - repetition - frequency mode, such as adding dedicated beam - absorbing devices and shielding measures. In conclusion, this paper provides important scientific basis and technical support for radiation safety management in the CLAPA - T facility, which is helpful to ensure the safety of experimental personnel and the smooth progress of the experiment.