The Deterioration of C-S-H Gel in a Severe Sulfate Environment

Wei Liao,Chunhua Lu,Zhongzi Xu
DOI: https://doi.org/10.3390/sym16060703
2024-06-07
Symmetry
Abstract:Immersion tests with 5 wt.% Na2SO4 solution were carried out to investigate the deterioration of calcium silicate hydrate (C-S-H) gel in a sulfate environment. C-S-H gels with different Ca/(Si + Al) molar ratios were used for comparison. Particular attention was paid to the changes in element composition and Si-O-Si chain structure of the C-S-H gel. The results show that the C-S-H gels with a low Ca/(Si + Al) ratio (0.8–1.0) and appropriate Si-O-Si chain length (14.8) presented better stability in a severe sulfate environment. The C-S-H gels with a higher Ca/(Si + Al) ratio (>2.0) were more sensitive to the attack of sulfate ions. Calcium ions dissolved rapidly during the immersion process, causing the loss of cohesive strength of the C-S-H gel, and then decomposed into fine particles. The C-S-H gel with a lower Ca/(Si + Al) ratio (about 1.1) rarely leached out calcium ions and maintained good micromorphology. The 29Si MAS-NMR results indicate that the Si-O-Si chains with too short or too long chain lengths will break and recombine under the attack of sulfate ions. The Si-O-Si chains with an appropriate chain length (14.8) maintained the stability of the structure of the C-S-H gel in a sulfate environment. These changes are closely related to the asymmetric layered structure of amorphous C-S-H gel. Partial calcium ions between the layers of the main chain structure of Si-O-Si are easily taken away by sulfate ions, leading to the structural instability of the C-S-H gel.
multidisciplinary sciences
What problem does this paper attempt to address?
The paper primarily explores the degradation of calcium silicate hydrate (C-S-H) gel in a sulfate environment. Specifically, the study focuses on the stability of C-S-H gels with different Ca/(Si + Al) molar ratios in a 5 wt.% Na₂SO₄ solution. The research investigates C-S-H gels of various compositions through immersion tests, with particular attention to changes in elemental composition and the Si-O-Si chain structure within the C-S-H gel. The study finds that in a sulfate environment, C-S-H gels with lower Ca/(Si + Al) ratios (approximately 0.8-1.0) and appropriate Si-O-Si chain lengths (around 14.8) exhibit better stability. In contrast, C-S-H gels with higher Ca/(Si + Al) ratios (greater than 2.0) are more sensitive to sulfate ion attack, leading to rapid dissolution of calcium ions, which in turn causes the C-S-H gel to lose cohesion and decompose into fine particles. Additionally, the research points out that shorter or excessively long Si-O-Si chains within the C-S-H gel tend to break and reorganize under sulfate ion attack, whereas Si-O-Si chains of appropriate length (about 14.8) can maintain structural stability in a sulfate environment. These changes are closely related to the asymmetric layered structure of amorphous C-S-H gel. In summary, this study aims to understand the behavior characteristics of C-S-H gel under sulfate attack, which is of significant reference value for improving the sulfate resistance of concrete.