Residual oil and suspended solid removal using natural adsorbents chitosan, bentonite and activated carbon: A comparative study

A.L. Ahmad,S. Sumathi,B.H. Hameed
DOI: https://doi.org/10.1016/j.cej.2005.01.016
IF: 15.1
2005-04-01
Chemical Engineering Journal
Abstract:Palm oil mill effluent (POME), which contains about 4000mg/l of residual oil, has been chosen to remove its residual oil using three types of adsorbents. Jar-test method has been used to identify the best adsorbent to remove the residual oil from POME. Chitosan was compared to activated carbon and bentonite as a potential residual oil remover. Chitosan showed the best removal compared to the other adsorbents for all the parameters studied. Chitosan could successfully remove 99% of residual oil and minimize the suspended solid content to a value of 25mg/l from POME at a dosage of 0.5g and employing a mixing time of 30min, a mixing rate of 100rpm, sedimentation for 30min and a pH value of ranging from 4.0 to 5.0. For activated carbon and bentonite, the optimum dosages were 8.0g and 10.0g/l, respectively, 30min of mixing time at 150rpm, 80 and 60min of settling time, respectively, and pH of 4.0–5.0 to obtain the same percentage of removal as performed by chitosan. Activated carbon and bentonite can only reduce the suspended solid values up to 35 and 70mg/l, respectively, at the optimized conditions.
engineering, chemical, environmental
What problem does this paper attempt to address?