Abstract:As a typical ferroelectric material, the PbZr1−xTix O3 (PZT) thin film with a homogeneous component has drawn extensive attention to the application in self-powered flexible electronics. The design of compositionally graded PZT thin films (i.e. artificially control the Zr/Ti ratio in different compositional layers in one film) has shown its immense potentials due to some novel phenomena induced by strain gradient, such as the shifted hysteresis loop, generation of the built-in electric field, enhancement in the motion of domain wall. However, the effect of the compositionally graded heterostructure on the piezoelectric response and its performance on the device level has seldom been investigated. To fill this knowledge gap, we prepare PZT thin films with the compositionally graded structure and based on that, fabricate flexible piezoelectric nanogenerators (PENGs). Furthermore, we explore the 2D mica as the substrate of PENGs and avoid the commonly used costly and troublesome laser-lifting or etching transfer procedure. The PENG prototypes integrated with 1 µm thick PZT films are flexible, translucent, and show high electric responses under different mechanical stimuli. Experiments indicate that up-graded PZT films, of which Zr composition varies from 20% near the bottom to 80% at the top, outperforms the down-graded counterpart. The up-graded PENG achieves a maximum voltage response of 2 V and a current density of 10.0 μA/cm2 when bent by <math>90°</math>. This work demonstrates that the strain-tuned compositionally graded structure is an effective approach to improve the PENG performance.

What problem does this paper attempt to address?

The paper focuses on addressing the following issues: 1. **Exploring the effect of strain gradient on the performance of PZT films:** The paper investigates the potential of PZT films designed through composition gradients (i.e., artificially controlled Zr/Ti ratios within a single film), which exhibit significant potential due to new phenomena induced by strain gradient (e.g., hysteresis loop shift, built-in electric field generation, enhanced domain wall motion). However, there is limited research on the impact of compositional gradient heterostructures on the piezoelectric response and their performance at the device level. 2. **Optimizing the performance of Piezoelectric Nanogenerators (PENGs):** To fill the knowledge gap, researchers prepared PZT films with compositional gradient structures and used them to fabricate flexible and transparent PENGs. They also explored the use of two-dimensional mica as the substrate for PENGs, avoiding the expensive and cumbersome laser delamination or etching transfer procedures typically used. 3. **Enhancing the application potential of PENGs in human monitoring:** Experimental results indicate that the performance of upgraded PZT films (Zr composition varying from around 20% at the bottom to 80% at the top) is superior to that of downgraded versions, suggesting that strain-tuned composition gradient structures are an effective method to improve PENG performance. In addition, these prototype PENGs integrate a 1-micrometer-thick PZT film and exhibit high electrical response under different mechanical stimuli, demonstrating their potential in human motion monitoring. In summary, the paper aims to improve the piezoelectric performance of PZT films through composition gradient engineering, thereby optimizing the design of piezoelectric nanogenerators for higher efficiency and practicality in self-powered flexible electronic devices, especially in the field of human motion monitoring.

Flexible and translucent PZT films enhanced by the compositionally graded heterostructure for human body monitoring