Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

Design of miniaturized and highly selective frequency selective rasorber based on compact spiral resonator

A miniaturized frequency selective rasorber with high selectivity passband and wideband absorption properties

Miniaturized Frequency-Selective Rasorber with a Wide Transmission Band Using Circular Spiral Resonator

Multi-characteristic Integrated Ultra-wideband Frequency Selective Rasorber

A Wideband Transmission Frequency Selective Surface Rasorber

Miniaturized Frequency Selective Rasorber with Absorption in S–C Band and Transmission in X Band

Ultrathin and Simple Frequency Selective Rasorber Based on Ferrite Absorber with Embedded Epsilon-Near-Zero Tunneling Channels

High-Selectivity Frequency-Selective Rasorber Based on Low-Profile Bandpass Filter

Design of a Wideband Absorption Frequency Selective Rasorber Based on Double Lossy Layers

Ultrathin and Simple 3-D Rasorber Based on Ferrites with Embedded Epsilon-Near-Zero Waveguides

Miniaturized Lossy-Layer Scheme For Designing a Frequency Selective Rasorber

Novel Frequency-Selective Rasorber with Ultrawide Absorption Bandwidth Covering Both the X- and Ku-Bands

A Wideband Transmission Frequency Selective Surface Rasorber with Low Insertion Loss

Frequency selective rasorber based on cross bend resonators for wideband transmission and absorption

A Frequency-Selective Surface Rasorber Based on Four Functional Layers

Design of Dual-Band Frequency-Selective Rasorber

Interdigitated Resonator Based Frequency Selective Rasorber with High Selectivity

Miniaturised Frequency Selective Surface‐based Rasorber with Wideband Two‐sided Absorption and Switchable Transmission/reflection Band

Low-Profile FSS-Based Polarization-Insensitive Rasorber with Switchable Transmission Band

Design of a Frequency Selective Rasorber Based on a Band-Patterned Octagonal Ring

Frequency Selective Rasorber with Broadband Transmission Window Using Characteristic Modes Analysis