Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

Wideband Frequency-selective Rasorber Based on 2.5-D Circuit Analog Absorber

Multi-characteristic Integrated Ultra-wideband Frequency Selective Rasorber

A Wideband Transmission Frequency Selective Surface Rasorber

Novel Frequency-Selective Rasorber with Ultrawide Absorption Bandwidth Covering Both the X- and Ku-Bands

Design of a Wideband Absorption Frequency Selective Rasorber Based on Double Lossy Layers

A miniaturized frequency selective rasorber with high selectivity passband and wideband absorption properties

Ultrathin and Simple Frequency Selective Rasorber Based on Ferrite Absorber with Embedded Epsilon-Near-Zero Tunneling Channels

Frequency Selective Rasorber with Broadband Transmission Window Using Characteristic Modes Analysis

A Frequency-Selective Surface Rasorber Based on Four Functional Layers

Ultrathin and Simple 3-D Rasorber Based on Ferrites with Embedded Epsilon-Near-Zero Waveguides

High-Selectivity Frequency-Selective Rasorber Based on Low-Profile Bandpass Filter

A Broadband Tunable Frequency Selective Surface Absorber For Oblique Incidence Applications

Low-Profile FSS-Based Polarization-Insensitive Rasorber with Switchable Transmission Band

Miniaturised Frequency Selective Surface‐based Rasorber with Wideband Two‐sided Absorption and Switchable Transmission/reflection Band

A Wideband Transmission Frequency Selective Surface Rasorber with Low Insertion Loss

Frequency selective rasorber based on cross bend resonators for wideband transmission and absorption

When Liquid Meets Frequency-Selective Rasorber: Wideband and Switchable 3-D Frequency-Selective Rasorber

Low Frequency Absorption-High Frequency Transmission Tunable Frequency Selective Rasorber

Broad bandwidth of thin composite radar absorbing structures embedded with frequency selective surfaces

A Thin and Broadband Tunable Radar Absorber Using Active Frequency Selective Surface

Design of a Tunable Low-Frequency and Broadband Radar Absorber Based on Active Frequency Selective Surface