O3 oxidation excited by yellow phosphorus emulsion coupling with red mud absorption for denitration

Bin Li,Yu Liu,Xingting Zhao,Ping Ning,Xiaolong Liu,Tingyu Zhu
DOI: https://doi.org/10.1016/j.jhazmat.2020.123971
IF: 13.6
2021-02-01
Journal of Hazardous Materials
Abstract:<p>Directing to unwieldiness NOx emitted by the industry, the removal of NOx was implemented using yellow phosphorus (P<sub>4</sub>) emulsion and red mud slurry as composite absorbent. Where yellow phosphorus is considered to stimulate formation of the ecological ozone (O<sub>3</sub>) from O<sub>2</sub>, the oxidation of insoluble NO into water-soluble NOx species by O<sub>3</sub>, and the red mud as a pH buffer can be used to maintain the pH of the absorption liquid in a range that better absorbs NOx. NO is finally converted into NO<sub>2</sub><sup>−</sup> and NO<sub>3</sub><sup>−</sup>, whereas the yellow phosphorus is mainly PO<sub>4</sub><sup>3−</sup>. Single-factor influencing on the efficiency of denitration include the concentration of yellow phosphorus, reaction temperature, stirring intensity, gas flow rate, O<sub>2</sub> content, and red mud solid-liquid ratio were investigated. Response surface methodology (RSM) was used to optimize the process parameters. It was indicated that the removal rate of NOx can reach 99.3% under the optimal conditions. Moreover, the possible denitration reaction mechanism was also discussed.</p>
environmental sciences,engineering, environmental
What problem does this paper attempt to address?