Abstract:In metal cutting, a large amount of mechanical energy converts into heat, leading to a rapid temperature rise. Excessive heat accelerates tool wear, shortens tool life, and hinders chip breakage. Most existing thermal studies have focused on dry machining, with limited research on the effects of cutting fluids. This study addresses that gap by investigating the thermal behavior of cutting tools during continuous and interrupted turning with cutting fluid. Tool temperatures were first measured experimentally by embedding a thermocouple in a defined position within the tool. These experimental results were then combined with simulations to evaluate temperature changes, heat partition, and cooling efficiency under various cutting conditions. This work presents novel analytical and numerical models. Both models accurately predicted the temperature distribution, with the analytical model offering a computationally more efficient solution for industrial use. Experimental results showed that tool temperature increased with cutting speed, feed, and cutting depth, but the heat partition into the tool decreased. In continuous cutting, cooling efficiency was mainly influenced by feed rate and cutting depth, while cutting speed had minimal impact. Interrupted cutting improved cooling efficiency, as the absence of chips and workpieces during non-cutting phases allowed the cutting fluid to flow over the tool surface at higher speeds. The convective cooling coefficient was determined through inverse calibration. A comparative analysis of the analytical and numerical simulations revealed that the analytical model can underestimate the temperature distribution for complex tool structures, particularly non-orthogonal hexahedral geometries. However, the relative error remained consistent across different cutting conditions, with less error observed in interrupted cutting compared to continuous cutting. These findings highlight the potential of analytical models for optimizing thermal management in metal turning processes.

Temperature measurement in single point turning

Self-sensing of Cutting Temperature in Single Point Diamond Turning by a Boron-Doped Diamond Tool

Cutting Temperature and Force Data Acquisition and Measuring System Design in High Speed Machining

Dynamical Temperature Monitoring System Design for High-speed Cutting Based on Thin-film Thermocouples

A Comparative Review of Thermocouple and Infrared Radiation Temperature Measurement Methods during the Machining of Metals

Experimental Studies of Cutting Temperature During High-Speed Milling of Aerospace Aluminum

A Novel Approach to Measure the Chip Formation Temperature Using the Implanted Thermocouple Method

Temperature measurement performance of thin-film thermocouple cutting tool in turning titanium alloy

Thermocouple and Infrared Sensor-Based Measurement of Temperature Distribution in Metal Cutting

Cutting temperature measurement in turning using fiber-optic multi-spectral radiation thermometry and its application in tool wear status recognition

On The Measurement of Temperature in Material Removal Processes

Temperature Measurement and Numerical Prediction in Machining Inconel 718

Characterization of Tool–Chip Interface Temperature Measurement With Thermocouple Fabricated Directly on the Rake Face

Non-Contact Temperature Measurement by Infrared Pyrometer in High Speed Milling

A Locally Boron-Doped Diamond Tool for Self-Sensing of Cutting Temperature: Lower Thermal Capacity and Broader Applications

Characterization and Optimization of a Locally Boron-Doped Diamond Tool for Self-sensing of Cutting Temperature

Modeling and Monitoring of the Tool Temperature During Continuous and Interrupted Turning with Cutting Fluid

Machine Tool Selected Point Temperature Rise Identification Based on Operational Thermal Modal Analysis

REAL-TIME MEASUREMENT OF MACHINE TOOL TEMPERATURE FIELDS AND THEIR EFFECT ON MACHINING ERRORS

Cutting temperature measurement and prediction in machining processes: comprehensive review and future perspectives

A Novel Methodology for Measuring Ambient Thermal Effects on Machine Tools