Boosted charge transfer in oxygen vacancy-rich K+ birnessite MnO2 for water oxidation and zinc-ion batteries

MengXian Lin,Fuqiang Shao,Shuting Weng,Shanshan Xiong,Shuai Liu,Shuyao Jiang,Yanchao Xu,Yang Jiao,Jianrong Chen

DOI: https://doi.org/10.1016/j.electacta.2021.138147

IF: 6.6

2021-05-01

Electrochimica Acta

Abstract:<p>Manganese Dioxide (MnO₂) as an efficient cathode material for zinc-ions battery (ZIBs) and water oxidation has always been a research emphasis because of its rich crystal phases, tunnel and layered structure, which is conducive to the deintercalation / intercalation of zinc ions. However, the key bottleneck of MnO₂ electrode materials are their poor rate capability and electrochemical stability. Herein, we successfully obtained oxygen vacancy-rich K-birnessite MnO₂ (K_xMnO₂) by plasma etching strategy. K⁺ intercalation in MnO₂ can adjust the interlayer distances, which improves the structural stability of material, and constructs a tunable Zn²⁺ channel. Meanwhile, the oxygen vacancy is not only contribute to the fast adsorption and diffusion of electrolytic ions, but also to the rapid transfer of charges. In addition, the nano-structure could provide abundant reaction sites and short diffusion pathways. Remarkably, the K_xMnO₂ is used cathode material of ZIBs after plasma optimization treatment presents reversible specific capacity of 272 mAh g⁻¹ at 1 mA cm⁻², and then it could reach an admirable capacity of 310 mAh g⁻¹ after 100 cycles. As the oxygen evolution reaction (OER) electrocatalysts, the overpotential to reach 10 mA cm⁻² of K_xMnO₂ is 1.47V of versus RHE. The Tafel slope is 36 mV dec⁻¹, which is lower than that of the K_xMnO₂ without plasma treatment (244 mV dec⁻¹). This study provides a new opportunity to design low-cost and high-performance electrode materials for rechargeable zinc-ion batteries and OER catalyst by using plasma processing technology.</p>

electrochemistry