Abstract:The particle breakage of porous and angular calcareous sand (CS) at the high-stress level is essential on compression feature but less quantified. In this research, a series of compression experiments and laser particle size analyzer tests were conducted under different ending pressures considering relative compaction and fine-grained soil (FS) content to investigate compression behavior and particle breakage of CS. The results indicate that the rebound curves are almost horizontal with a rebound index are between 0.0021 and 0.0054, and the FS content (smaller than 10%) has a little impact on resilience behavior. The irreversible plastic deformation is the main part of compression deformation. Besides, there exist two pressure thresholds of 400 kPa and 100 kPa corresponding to void ratio change trend when FS contents are smaller than 10% and reach 10%, respectively. Moreover, with FS contents increase from 0 to 10%, the moving distance of grading curves to the right becomes shorter gradually which suggests that the quantities of particle crushability decrease. FS can relieve stress concentration among CS that leading to less particle crushability. The combination of these factors including FS content, relative compaction, and axial loading has a complex effect on the relative crushability ratio. Both FS content and relative compaction can restrain particle crushability while axial loading could promote particle crushing. In addition, the relative crushability ratio has a negative linear relation with FS content and relative compaction. But, the relation between particle crushability ratios with axial loading can be described as a logarithmic function well. However, when relative compaction increases to a certain degree of 0.7, the influence of pressure on the relative crushability ratio is weakened. Similarly, the effect of relative compaction on the void ratio is weakened when the FS content is increased. Furthermore, there is a good negative linear correlation between the void ratio and relative crushability ratio.

A hypoplastic model for crushable sand under a wide range of stress levels

Hypoplastic Model for Sand under Multidirectional Shearing Conditions Considering Fabric Change Effect

Hypoplastic Modeling of Anisotropic Sand Behavior Accounting for Rotation of Principal Stress Direction

Non-coaxial hypoplastic model for sand with evolving fabric anisotropy including non-proportional loading

A Hypoplastic Model for Granular Soils Incorporating Anisotropic Critical State Theory

Development of a modified hypoplastic model for calcareous sand considering particle crushing

A constitutive model for crushable sands involving compression and shear induced particle breakage

A Hypoplastic Constitutive Model for Granular Materials with Particle Breakage

A hypoplastic model for hydrate‐bearing sand considering hydrate saturation and grain breakage

Micro-and macro-mechanical behavior of crushable calcareous sand in South China Sea

A hypoplastic model for sand-fines mixtures

A state-dependent hyperelastic-plastic constitutive model considering shear-induced particle breakage in granular soils

An extended hypoplastic constitutive model considering particle breakage for granular material

One-dimensional compression feature and particle crushability behavior of dry calcareous sand considering fine-grained soil content and relative compaction

Study on Modified Dynamic Constitutive Model for Calcareous Sand considering Particle Breakage

DEM Modeling of Particle Breakage in Silica Sands under One-Dimensional Compression

Simulation Study of Breakage in Coral Sand Particles under Dynamic Confined Compression

Influence of Load Mode on Particle Crushing Characteristics of Silica Sand at High Stresses

Experimental investigation on mechanical behavior and particle crushing of calcareous sand retrieved from South China Sea

Three-Dimensional Discrete Element Analysis of Crushing Characteristics of Calcareous Sand Particles

DEM Simulation of Creep in One-Dimensional Compression of Crushable Sand