Abstract:Quality of optical signal can be severely degraded after a long distance optical fiber transmission, therefore all-optical 2R (re-amplification, re-shaping) regeneration is required for its low power consumption and good potential of high-speed operation. Semiconductor optical amplifier (SOA) is a very promising candidate for regeneration due to its relatively low nonlinear switching power threshold and possibility of integration. However, speeds of the existing 2R schemes based on SOAs are limited by pattern effects introduced by the long carrier recovery time. So far, most of experimental results for SOA-based regeneration schemes have been limited to 40 Gb/s, only a few demonstrations at 80 Gb/s are available. An effective method to cope with the pattern effects in the SOA is to employ cross gain compression (XGC) effect. Simultaneously injecting two signals of different wavelengths with complementary logics and balanced powers into the SOA leads to an almost constant ability to make the XGC effect intrinsically immune to the pattern effects. Previously, 2R experimental results were demonstrated at 10 Gb/s and 40 Gb/s with XGC respectively, but no further results of higher speed have been presented to date. In this study, we improve the previous two-stage configuration for XGC-based regeneration by introducing a transient cross phase modulation (T-XPM) in the first SOA for generating the high-quality logic-inverted signal, which, as we find, is essential to facilitating the high-speed XGC operation in the next SOA. Firstly, a numerical model of the photon-electron dynamics in an SOA is built with considering the ultrafast intra-band processes, amplified spontaneous emission (ASE) noise at multiple wavelengths, and device segmentation along propagation direction. The quality of the logic-inverted signal with different offsets of the filter wavelength for T-XPM is studied with the model. It is found that the appropriate blue-shift detuning of the filter wavelength greatly helps to improve the quality of the logic-inverted signal. In experiment, the influence of the filter offset on the quality of the logic-inverted signal is also investigated systematically and the best quality and the largest eye-opening of the logic-inverted signal are achieved with a blue-shift of 0.72 nm, which are consistent with the simulation result. With the best logic-inverted signal, XGC effect is deployed in the second SOA. Effective reduction of the amplitude fluctuation can be observed by comparing the eye diagrams of the input degraded with output regenerative signals. Bit error rates (BERs) are also measured for all four tributaries of the degraded and the regenerated signals and the receiving sensitivity at a BER of 10-9 is improved by 1.7-2 dB. Such results show that the XGC-based 2R regeneration scheme is effective even at a speed of as high as 100 Gb/s with the help of high-quality logic-inverted signal. Degraded signals at different wavelengths (from 1535 nm to 1555 nm) are successfully regenerated with Q-factor improvement, demonstrating the wavelength-independent regeneration capability of the XGC-based 2R regenerator.

Fiber-Based All-Optical Signal Regeneration

Performance Analysis and Comparison of Optical 3R Regenerators Utilizing Self-Phase Modulation in Fibers

Self-phase-modulation based all-optical regeneration of PDM signals using a single section of highly-nonlinear fiber

All-optical 2R Regeneration Based on Self-phase Modulation and Offset Filtering

Towards a photonic integrated all-optical phase regenerator

Transparent Signal Regeneration by High-Contrast Low-Threshold Optical Bistable Devices Based on Vertical Layered DFB/FP Structures

All-optical fiber signal processing and regeneration for soliton communications

All-Optical Simultaneous Multilevel Amplitude and Phase Regeneration

Converged Wireless and Wireline Access System Based on Optical Phase Modulation for Both Radio-Over-Fiber and Baseband Signals

All-Optical Signal Regeneration in Polarization-Division-Multiplexing Systems

Transparent Optical Signal Regeneration Using a Nonlinear Bistable Device

Phase regeneration of QPSK signals based on Kerr soliton combs in a highly nonlinear optical fiber

3R optical regeneration: an all-optical solution with BER improvement

Simultaneous All-Optical Demultiplexing and Regeneration Based on Self-Phase and Cross-Phase Modulation in a Dispersion Shifted Fiber

All-optical 3R regeneration for DPSK signal based on a semiconductor optical amplifier scheme

Impact of residual dispersion and ASE noise on the performance optimization of all-optical regenerators utilizing self-phase modulation in a highly nonlinear fiber

All-Optical 2r Regeneration For Nrz-Ook Signal Using Transient-Cross Phase Modulation And Cross Gain Compression In Soas

A Study of 100 Gb/s 2R Regeneration for Return-to-zero Code Signal

High-Performance Optical 3R Regeneration for Scalable Fiber Transmission System Applications

100-Gb/s all-optical wavelength-preserved 2R regeneration using semiconductor optical amplifiers

Investigation of self-phase modulation based optical regeneration in single mode As2Se3 chalcogenide glass fiber