Abstract:Phase change materials (PCMs) exploit their cyclic phase change (solidification and melting) to enable latent heat storage. While incorporating them in thermally activated building systems can potentially enhance energy savings and thermal comfort, they can introduce significant challenges to the building energy management system. This work first reports the result of small-scale side-by-side experiments on two thermally active cuboids with and without BioPCMs at different supply water and PCM melting temperatures, as well as irradiance levels. Next, a dynamic model is developed in TRNSYS v18.05 for a typical design of an office space under hot desert climate conditions. The model is then integrated into a multi-objective optimization routine using NSGA-II algorithms to identify the optimal characteristic cooling curves, melting temperatures, and PCM thicknesses that simultaneously minimize energy consumption and maximize the percentage of comfortable hours. The experimental observations of the PCM-integrated cuboid highlighted energy savings between 80.45 and 84.56 %, compared to the reference cuboid, at nearly the same levels of indoor temperatures. The PCM panels reduced the cooling capacity of the radiant floor but also dampened air temperature variations by up to 83.17 %. Besides, higher solar irradiance levels, encountered in desert areas, were found to enhance the cooling capacity by up to 46.8 %. The Pareto solutions highlighted the possibility of achieving acceptable unmet hours of 3.16 % using PCMs and without the need for an assisting air system, compared to 14.1 % without PCMs. Besides, at the same unmet hours of the reference system, the PCMs reduced the total energy consumption and the peak cooling power by 9.75 and 41.2 %, which translates into substantial operation and capital investments, respectively. Moreover, the study demonstrated by example the importance of calibrating the commonly used cooling curves of thermally active buildings when planning for PCM integration.

Thermal comfort enhancement of office buildings located under warm and humid climate through phase change material and insulation coupled with natural ventilation

Adjustable Insulation for Enhancing the Performance of Phase Change Materials in Buildings

Enhancing thermal comfort in buildings through the integration of phase change material on the building envelope: a simulation study

Numerical Simulation on the Thermal Performance of a PCM-containing Ventilation System with a Continuous Change in Inlet Air Temperature

Experimental Investigation and Numerical Modeling of Room Temperature Control in Buildings by the Implementation of Phase Change Material in the Roof

Phase change with inner ventilation for energy management: Roofs buildings in hot & dry climates case

Phase Change Materials Integrated Into the Building Envelope to Improve Energy Efficiency and Thermal Comfort

Optimizing the characteristic cooling curves of PCM-integrated thermally active buildings: Experimental and numerical investigations

Simulation and designing of PCM wallboard rooms combined with night ventilation

Numerical study on thermal comfort and energy-saving potential of a prefabricated temporary house integrated with composite phase change materials

A comparative evaluation on energy consumption of a building using bio-based and paraffin-based phase change materials integrated to external building envelope

New structure for better thermal resistance of building with phase change material: Response to milder thermal change than common walls

Incorporation of phase change materials into building envelope for thermal comfort and energy saving: A comprehensive analysis

The Impact of Integrating Phase Change Material Upon Indoor Air Temperature in Hot Climates

Phase Changing Material (PCM) based envelope materials for energy efficient buildings

Thermal performance and comfort potential estimation in low-rise high thermal mass naturally ventilated office buildings in India: An experimental study

Experimental Investigations for Thermal Energy Management by Encapsulation of Nano -Enhanced Bio Phase Change Material in buildings

Experimental study of the thermal and energy conservation characteristics of combined phase change material (PCM) room in summer

Dynamic integration of phase change material in walls for enhancing building thermal performance—A novel self-adaptive method for moving PCM layer

Evaluation of the Impact of Phase Change Humidity Control Material on Energy Performance of Office Buildings

Effect of phase change material integration in clay hollow brick composite in building envelope for thermal management of energy efficient buildings