All-nanophotonic switching in CuSySe1-y/PMMA freestanding nanocomposite films

Hadeel N. Abd,H.L. Saadon,Saeed J. Abbas
DOI: https://doi.org/10.1016/j.optmat.2024.114837
IF: 3.754
2024-02-01
Optical Materials
Abstract:Nanophotonic switching has received increasing attention due to their ability to overcome the limitation parameters of electronic switching. For application as an all-nanophotonic switching device, a new dual-polarized pump–probe scheme based on the nonlinear optical (NLO) response of material is presented. In this scheme, two lasers-linearly polarized beams were used to pump material separately. The scheme can effectively control photonic switcher parameters with a good switching time, high modulation depth, and low switching power even if the material generates a noise, due to the scattering or speckle. In this work, ternary CuSySe1-y/PMMA nanocomposite freestanding films were prepared in the composition range of 0 ≤ y ≤ 1 at a low temperature of 80 °C using a simple chemical method. The structural, morphological, and optical properties of the ternary CuSySe1-y/PMMA nanocomposite freestanding films were studied and characterized. Results showed that the crystallinity structure and tunable optical band gap of the ternary nanoplates CuSySe1-y/PMMA were affected by y composition. The NLO response at wavelength of 532 nm was studied using the Z-scan technique, and the films exhibited negative refractive index n2 and reverse saturable absorption β. Hence, all the nanocomposite films with various y compositions presented excellent figure of merits W and T, with best results obtained at y composition of 0.56. The all-optical switching effect of CuSySe1-y/PMMA nanocomposite freestanding films at various y compositions was also demonstrated. Compared with that at 532 nm, the pump laser at wavelength of 457 nm had faster response time and can be more effective for realizing all-nanophotonic switching device. The best results were achieved at y composition of 0.56 and optimum pump power of 25 mW with maximum modulation depth of 89.7 % and switching contrast of 9.9 dB at switching time of 19 ms in the frequency modulation of 8 Hz. The prepared all-nanophotonic switching device based on ternary CuSySe1-y/PMMA nanocomposite freestanding films provides a promising research direction and has potential application in photonic processing.
materials science, multidisciplinary,optics
What problem does this paper attempt to address?