Abstract:Increasing the use of steel scrap and enhancing its recycling utilization are important strategies for fostering the low-carbon and environmental-friendly growth of the iron and steel industry in China. However, the current steelmaking processes cannot efficiently remove the residual elements in the scrap, such as Cu, Sn, As, and Sb. As a result, the above elements are recycled and accumulate in the scrap, which will eventually have a negative impact on the properties of steel. Currently, there are few studies on Sb removal from molten steel. To remove the residual element Sb in molten steel, the CaO-SiO2-Al2O3 refining slag system containing CaC2 was used, and the effect of the CaC2 content in the molten slag, slag quantity, smelting temperature, and initial Sb and C contents in molten steel on the Sb removal ratio in the steel was investigated, and the mechanism of Sb removal by the aforementioned refining slag system was discussed in order to provide some experimental and theoretical basis for industrialization practice. When the smelting time is 5~10 min, the removal ratio of Sb from molten steel is at its peak and can reach 45.8%. The "Sb-reversion" phenomenon will appear in the molten steel when the smelting period is progressively extended. In molten steel, CaC2 will preferentially react with O and S, and as the smelting temperature decreases, the distribution ratio of Sb, LSb, improves. An increased initial Sb content in molten steel and slag quantity are beneficial to improving the removal ratio of Sb, but an increased initial C content in molten steel is detrimental to the progress of the Sb removal reaction. The removal reaction of Sb from molten steel by CaC2 is a reversible reaction, and the diffusion of the products from the interface is the limiting factor of the overall reaction.

Antimony recovery from antimony-rich slag by top blowing nitrogen into the molten slag bath

Cleaning of high antimony smelting slag from an oxygen-enriched bottom-blown by direct reduction

Phase Evolution and Recovery Rate of Sb in Lead–Silver Slag Treated via Melting–Fuming Method

Recovery of valuable metals from electroplating sludge with reducing additives via vitrification

Process flowsheet development for selective arsenic removal, lead and antimony recovery from lead softening slag

Study on the High-temperature Properties of High-titania Slags produced with Cr-bearing Vanadia-titania Magnetite Smelting in Blast Furnace

Artificial Slags with Modulated Properties for Controlled Nickel Dissolution in Smelting Process

Clean recycling of Zn-bearing slags by a plasma fuming process

Thermodynamics analysis and experiments on Ti-bearing blast furnace slag leaching enhanced by sulfuric acid roasting

Sb recovery from an As pre-removed lead anode slime using a ZnS-Na2CO3 smelting reduction

Electroreduction of Antimony Sulfide Enhanced by Nitrogen Bottom Blowing in Molten NaCl-KCl-Na2S

Fluid flow, slag entrainment, and composition evolution of slag inclusions during vacuum degassing refining

Recovery of Fe, Ni, Co, and Cu from Nickel Converter Slag through Oxidation and Reduction

Oxidation transformation and vacuum separation for direct preparation of antimony trioxide products from lead anode slime

Research of the evaporation law of elemental antimony under vacuum

Recovery of Valuable Metals from Nickel Smelting Slag Based on Reduction and Sulfurization Modification

Thermal modification of copper slag via phase transformation for simultaneous removal of SO2 and NOx from acid-making tail gas

Removal of Residual Element Antimony from Molten Steel by CaC2-Containing Refining Slag

The Recovery of Ammonia Nitrogen From Aluminum Slag Ashes

Mass Transfer Model of Desulfurization in the Electroslag Remelting Process

Volatilisation Behaviour and Mechanism of Lead-Containing Slag during Physical Property Tests