Abstract:Nano-sized aluminum (Nano-Al) powders hold promise in enhancing the total energy of explosives and the metal acceleration ability at the same time. However, the near-detonation zone effects of reaction between Nano-Al with detonation products remain unclear. In this study, the overall reaction process of 170 nm Al with RDX explosive and its effect on detonation characteristics, detonation reaction zone, and the metal acceleration ability were comprehensively investigated through a variety of experiments such as the detonation velocity test, detonation pressure test, explosive/window interface velocity test and confined plate push test using high-resolution laser interferometry. Lithium fluoride (LiF), which has an inert behavior during the explosion, was used as a control to compare the contribution of the reaction of aluminum. A thermochemical approach that took into account the reactivity of aluminum and ensuing detonation products was adopted to calculate the additional energy release by afterburn. Combining the numerical simulations based on the calculated afterburn energy and experimental results, the parameters in the detonation equation of state describing the Nano-Al reaction characteristics were calibrated. This study found that when the 170 nm Al content is from 0% to 15%, every 5% increase of aluminum resulted in about a 1.3% decrease in detonation velocity. Manganin pressure gauge measurement showed no significant enhancement in detonation pressure. The detonation reaction time and reaction zone length of RDX/Al/wax/80/15/5 explosive is 64 ns and 0.47 mm, which is respectively 14% and 8% higher than that of RDX/wax/95/5 explosive (57 ns and 0.39 mm). Explosive/window interface velocity curves show that 170 nm Al mainly reacted with the RDX detonation products after the detonation front. For the recording time of about 10 μs throughout the plate push test duration, the maximum plate velocity and plate acceleration time accelerated by RDX/Al/wax/80/15/5 explosive is 12% and 2.9 μs higher than that of RDX/LiF/wax/80/15/5, respectively, indicating that the aluminum reaction energy significantly increased the metal acceleration time and ability of the explosive. Numerical simulations with JWLM explosive equation of state show that when the detonation products expanded to 2 times the initial volume, over 80% of the aluminum had reacted, implying very high reactivity. These results are significant in attaining a clear understanding of the reaction mechanism of Nano-Al in the development of aluminized explosives.

Dependence of the TNT Equivalent of an Underwater Explosion on the Content of Aluminum Hydride in an Energy Material

Influence of Al Content and Surrounding Medium on the Energy Output of Cyclotrimethylenetrinitramine (rdx)/al/wax Explosives

Reactive molecular dynamics simulation of thermal decomposition for nano-AlH3/TNT and nano-AlH3/CL-20 composites

Effect of Aluminum Additive on the Detonation Temperature of an Emulsion Explosive

The effect of Mg(BH4)2 on the energy characteristics of RDX based aluminized explosives

The effect of active aluminum content on the detonation performance of aluminized explosives

Effects of Aluminum Particle Size on the Detonation Pressure of TNT/Al

Explosion mechanism of aluminum powder mixed with low-concentration hydrogen

Research of detonation products of RDX/Al from the perspective of composition

Effect of metal dust fuel at a low concentration on explosive/air explosion characteristics

Effect of aluminum content on detonation velocity and density of emulsion explosives

Energy and blast performance of beryllium in a model thermobaric composition in comparison with aluminum and magnesium

Effect of Mass Ratio on Flame Propagation Behaviors and Thermal Radiation Performance of Al–AlH3 Composite Dust

Study on Energy Output Characteristics of Aluminized Emulsion Explosive

Effect of AlH3 on the Energy Performance and Combustion Agglomeration Characteristics of Solid Propellants

On weak influence of aluminum powder size on its post-detonation reaction in different time scales

Study on explosion reaction mechanism and energy release characteristics of HMX-based explosives containing B-Al

Effects of nano-sized aluminum on detonation characteristics and metal acceleration for RDX-based aluminized explosive

Preparation, characterization, and investigation of thermal behavior of improved HMX and RDX through coating by TNT

Effect of water on the thermal stability of alpha-aluminum hydride

Influence of overdriven detonation on the energy release of aluminized explosives in underwater explosion