Abstract:Currently, layered Ni-rich cathodes of LiNi x Mn y Co z O 2 ( x ≥ 0.8) have gained significant attention for high energy density Li-ion batteries (LIBs) owing to their high specific capacity of ∼200 mA h g −1 within a limited voltage range. However, the large-scale use of these cathodes is severely limited by their poor structural stability, high surface reactivity, and severe capacity fading resulting from intergranular microcracks triggered by large volume changes and formation of rock salt in the highly de-lithiated state. Considering the demand for high specific capacity and high cycling stability cathodes, a core–shell oxide material 0.8LiNi 0.85 Mn 0.10 Co 0.05 O 2 –0.2Li 1.2 Ni 0.16 Mn 0.56 Co 0.08 O 2 (NR-CS) with a Ni-rich oxide core of LiNi 0.85 Mn 0.10 Co 0.05 O 2 (NMC85) and an outer shell of a Mn-based Li-rich Li 1.2 Ni 0.16 Mn 0.56 Co 0.08 O 2 oxide is synthesized. The NR-CS material delivered an initial discharge capacity of 212 mA h g −1 when cycled at 20 mA g −1 (0.1C rate) in the potential range of 2.8–4.3 V vs. Li with 89% capacity retention after 120 cycles when tested in half-cells using Li anodes. Additionally, we compared its performance with Ni-rich oxide NMC85 alone and with integrated materials of both Ni-rich and Mn-based Li-rich oxides (NR–LR). It was found that the Ni-rich oxide NMC85 cathodes could deliver a specific capacity of 216 mA h g −1 with around 67% capacity retention, and those comprising the Li and Mn-rich NMC material possessed a specific capacity of 140 mA h g −1 with 71.4% capacity retention when cycled under similar experimental conditions at 0.1C in the potential range of 2.8–4.3 V vs. Li after 120 cycles. Thus, the core–shell structure benefits from the high capacity of the core (Ni-rich NMC85) and surface chemical stability of the Mn-based Li-rich oxide. Moreover, when tested in full Li-ion cells with pre-lithiated graphite anodes, graphite‖NR-CS cells could provide a discharge capacity of about 170 mA h g −1 and an energy density of 274 W h kg −1 during 200 cycles when cycled at 0.5C rate. Thus, this study highlights the importance of the core–shell structure of Ni-rich NMC oxide cathodes over Ni-rich oxide or Li- and Mn-rich NMC cathodes in providing high capacity, higher rate and better cycling stability when charged up to 4.3 V in LIBs.

Architecting “Li-rich Ni-rich” core-shell layered cathodes for high-energy Li-ion batteries

Radially Oriented Single‐Crystal Primary Nanosheets Enable Ultrahigh Rate and Cycling Properties of LiNi0.8Co0.1Mn0.1O2 Cathode Material for Lithium‐Ion Batteries

Intrinsic Highly Conductive and Mechanically Robust Li‐Rich Cathode Materials Enabled by Microstructure Engineering for Enhanced Electrochemical Properties

Synthesis and characterization of core–shell high-nickel cobalt-free layered LiNi0.95Mg0.02Al0.03O2@Li2ZrO3 cathode for high-performance lithium ion batteries

Spinel LiNi0.5Mn1.5O4 shell enables Ni-rich layered oxide cathode with improved cycling stability and rate capability for high-energy lithium-ion batteries

Advantageous electrochemical behaviour of new core–shell structured cathodes over nickel-rich ones for lithium-ion batteries

Binary-compositional core-shell structure Ni-rich cathode material with radially oriented primary particles in shell for long cycling lifespan lithium-ion batteries

Both Interface and Bulk Stable LiNi 0.5 Mn 1.5 O 4 Cathodes for High-Energy Li-Ion Batteries

Lanthanum doping and surface Li 3 BO 3 passivating layer enabling 4.8 V nickel-rich layered oxide cathodes toward high energy lithium-ion batteries

Ni-Rich Layered Oxide with Preferred Orientation (110) Plane as a Stable Cathode Material for High-Energy Lithium-Ion Batteries

Well-ordered layered LiNi0.8Co0.1Mn0.1O2 submicron sphere with fast electrochemical kinetics for cathodic lithium storage

Synthesis and Characterization of the Lithium-Rich Core–Shell Cathodes with Low Irreversible Capacity and Mitigated Voltage Fade

Enhanced interfacial reaction interface stability of Ni-rich cathode materials by fabricating dual-modified layer coating for lithium-ion batteries

Well-ordered Layered LiNi 0.8 Co 0.1 Mn 0.1 O 2 Submicron Sphere with Fast Electrochemical Kinetics for Cathodic Lithium Storage

Realization of a High-Voltage and High-Rate Nickel-Rich NCM Cathode Material for LIBs by Co and Ti Dual Modification

Towards Rational Design of High Performance Ni-rich Layered Oxide Cathodes: the Interplay of Borate-Doping and Excess Lithium

Hierarchical yolk-shell structured Li-rich cathode boosting cycling and voltage stabled LIBs

Surface to Bulk Synergetic Modulation of Nickel‐Rich LiNi0.83Co0.06Mn0.11O2 via a Three‐in‐One Approach for Long‐Cycle Lithium‐Ion Batteries

Stabilizing reaction interface in Ni-rich layered oxides cathode for high-performance lithium-ion batteries at a high cutoff voltage

Thermochemical Cyclization Constructs Bridged Dual-Coating of Ni-Rich Layered Oxide Cathodes for High-Energy Li-Ion Batteries

Enhanced long-term cyclability in Li-Rich layered oxides by electrochemically constructing a LixTM3-xO4-type spinel shell