Abstract:An ESCALAB High Pressure photoelectron spectrometer specially designed by Vacuum Generators Co. (UK) for in-situ measurements at high pressures has been modified for adsorption and catalytic experiments. New construction of a gas cell, which serves to create a high-pressure zone, allows us to measure photoemission spectra in-situ at pressures up to 0.2–0.5 mbar and to use a sample holder with independent heating of a sample. This makes it possible to measure temperature programmed desorption and reaction spectra and, as a consequence, to characterize the catalytic properties simultaneously with the acquisition of X-ray photoelectron spectroscopy (XPS) data. Capabilities of the modified spectrometer are demonstrated by the examples of studies of CO and methanol adsorption on Pd(111) single crystal and methanol oxidation over Cupoly.The XPS study of high-pressure adsorption of CO on perfect and sputtered Pd(111) showed that raising the pressure has the same effect as decreasing the temperature. The CO coverage is increased due to adsorption of CO to weakly bound (on-top) state, which appears in addition to more strongly bound three-fold and bridged species. No indications of CO dissociation or carbonyl formation were found under the given experimental conditions (high pressure and sputtering-induced defects), provided that the CO gas was sufficiently clean.Two pathways of methanol decomposition to CHx, ads (x≤3) and to COads was unambiguously identified, with their contribution being dependent on P and T. The decomposition to carbon-originated species had a small contribution in UHV conditions at room temperature, but became more significant at higher pressures and temperatures.Analysis of the distribution of the reaction products and surface species during methanol oxidation over copper in the sub-millibar pressure range showed that an increase in catalytic activity observed on heating the sample from 420 to 670 K is accompanied by transformation of the adlayer composition. At low temperatures, the surface is covered by methoxy- and, to a lesser extent, formate-groups. The active surface (T > 520 K) is metallic copper with two adsorbed oxygen species. The possible nature of these species is discussed.

X-ray photoelectron spectroscopy (XPS) for catalysts characterization

Advanced XPS-Based Techniques in the Characterization of Catalytic Materials: A Mini-Review

Practical chemical analysis of Pt and Pd based heterogeneous catalysts with hard X-ray photoelectron spectroscopy

Improving time-resolution and sensitivity of in situ X-ray photoelectron spectroscopy of a powder catalyst by modulated excitation

X-ray Photoelectron Spectroscopy as a useful tool to study surfaces and model systems for heterogeneous catalysts: A Review and Perspective

A Versatile Approach to Electrochemical In Situ Ambient-Pressure X-ray Photoelectron Spectroscopy: Application to a Complex Model Catalyst

X-ray photoelectron spectroscopy as a tool for in-situ study of the mechanisms of heterogeneous catalytic reactions

In situ X-ray photoelectron spectroscopy of model catalysts: At the edge of the gap

In Situ Characterization of Catalysis and Electrocatalysis Using APXPS

Understanding Catalyst Surfaces during Catalysis through Near Ambient Pressure X-ray Photoelectron Spectroscopy

Practical guide for x-ray photoelectron spectroscopy: Applications to the study of catalysts

Combining In-Situ Transmission Electron Microscopy and Infrared Spectroscopy for Understanding Dynamic and Atomic-Scale Features of Supported Metal Catalysts

Role of catalyst shape and reactor performance for relating the catalytic activity and the chemical structure of active sites for emission control catalysis

Application of XPS to study electrocatalysts for fuel cells

On the Application of an In Situ Catalyst Characterization System (ICCS) and a Mass Spectrometer Detector as Powerful Techniques for the Characterization of Catalysts

In Situ X-ray Absorption Fine Structure (XAFS) Applied to Catalyst Characterization at UOP: Examples and Perspectives

A Theory-Guided X-ray Absorption Spectroscopy Approach for Identifying Active Sites in Atomically Dispersed Transition-Metal Catalysts.

Unraveling Catalytic Reaction Mechanism by In Situ Near Ambient Pressure X-ray Photoelectron Spectroscopy

Direct Evidence of Dynamic Metal Support Interactions in Co/TiO2 Catalysts by Near-Ambient Pressure X-ray Photoelectron Spectroscopy

Towards an understanding of the chemisorption and catalytic activity of Pd$_{X}$Ru$_{1-X}$ nanoparticles using photoelectron spectroscopy

Valence-to-core X-ray emission spectroscopy to resolve the size-dependent valence electronic structure of Pt nanoparticles