Abstract:This study involves the development of a Suspension system for FSAE vehicles participating in the Combustion Category. The front setup is also introduced with a bar-type Anti-Roll Bar (ARB) to manipulate the Understeer and Oversteer response of the vehicle. The initial parametric study was performed with an iterative approach in the spreadsheet. Race-cars also have stiffer suspension i.e.; the ride frequency is above 2 Hz; the reason being that the driver does strict maneuvering on the race track. FSAE vehicles have ARB's for better cornering performance and to manipulate the response of the vehicle mainly understeer and oversteer suiting to the driver. Another advantage is the limitation of camber gain caused by the body roll as it improves the traction. Further, the Kinematic study of all the components in the system was analyzed through IPG Kinematic Software. The focus was made on the variation of Camber Angle, Steer Angle, Track Change, and Roll Angle with and without the ARB incorporation. The calculation for the selection of different bearings is also performed. Considering the previous vehicles and the new design goals, parametrizing of the vehicle is also performed. The overhang of the vehicle plays an important factor in the longitudinal load transfer during the braking and acceleration. Forces experienced by all the components were also extracted from the software. This data is then used as the input parameter for Structural Simulation on CAE platform ANSYS. Material properties of Aluminum 6061 T-6 are used for the Bell Cranks and carbon Steel is used for ARB setup. Static structural simulation is performed on the Front Rocker, Upright and Hub. Specific torsional simulation is done on the ARB considering the axial offset position of the support bearing and the loading point on the blade.

Modelling and Analysis of Off-Road Rally Vehicle using Adams Car

The Study on the Handling and Stability Test of Vehicles Based on ADMS and WTK

Analyses on Vehicle Ride Comfort Based on Virtual Prototype Technology

Road-friendliness of interconnected hydro-pneumatic suspension based on ADAMS/Simulink/AMESim

Simulation Analysis of Vehicle Handing Stability Based on ADAMS/Car

Study of an articulated vehicle dynamic modeling based on virtual environment

Analysis of Passenger Car Suspension System Using Adams

Dynamic Analysis of Car Suspension Using ADAMS/Car for Development of a Software Interface for Optimization

Development and Validation of a Simulation Model of Automotive Suspension System using MSC-ADAMS

Kinematic and Structural Analysis of Independent type suspension system with Anti-Roll bar for Formula Student Vehicle

Vehicle Steering Stability Researched by Redeveloped Module of ADAMS/CAR

The Analysis and Optimization on the Front Suspension System of a Formula Racing Car Based on ADAMS

Vehicle Suspension K&C Characteristic Simulation Analysis Based on ADAMS

Modeling and Simulation of Active Front Steering System Based on ADAMS

Modeling and simulation of macpherson suspension for kinematics and elastic kinematics based on ADAMS/Car

Modeling and Kinematics Characteristic Analysis of Twist Beam Rear Suspension Using ADAMS/Car

Modelling of SOLO’s Car Suspension System

Simulation and optimization of FSAE racing suspension

CAE Analysis Modeling Technique and Application of Car Multi-body System Dynamics

Influence on Simulation Result by Accuracy of Suspension Key Points in ADAMS Full Vehicle Modelling