A novel solar hydrogen production system integrating high temperature electrolysis with ammonia based thermochemical energy storage

Chen Chen,Qi Xia,Shuaiming Feng,Qibin Liu
DOI: https://doi.org/10.1016/j.enconman.2021.114143
IF: 10.4
2021-06-01
Energy Conversion and Management
Abstract:<p>In this paper, a novel solar hydrogen production system integrating high temperature electrolysis (using solid oxide electrolyzer cell) with ammonia based thermochemical energy storage is proposed for the first time. Without a significantly high concentration ratio, the thermochemical energy storage can upgrade relatively low-temperature solar energy to high-temperature reaction heat for high temperature electrolysis (HTE). Furthermore, thermal coupling of ammonia based thermochemical energy storage system, sCO<sub>2</sub> Brayton cycle and HTE will result in substantially higher fuel production efficiency as compared to conventional low-temperature water electrolysis. A system model, including ammonia based thermochemical energy storage, sCO<sub>2</sub> Brayton cycle and solid oxide electrolyzer cell (SOEC) system, has been developed using the Aspen Plus software implemented with user-defined Fortran subroutines. The models including reactors, sCO<sub>2</sub> Brayton cycle and SOEC have been validated by comparing the model-generated results with the data from references. The effects of the endothermic reactor inlet temperature <em>T</em><sub>2</sub>, charging loop ammonia mass flow rate <span class="math"><math>ṁc</math></span>, turbine inlet temperature <em>T</em><sub>11</sub> and current density <em>J</em> on the system performance have been investigated parametrically. The results show that the solar to hydrogen efficiency <span class="math"><math>ηSTH</math></span> increases with <em>T</em><sub>2</sub>, <em>T</em><sub>11</sub> and <em>J</em> increasing. In addition, there is an optimum <span class="math"><math>ηSTH</math></span> by varying <span class="math"><math>ṁc</math></span>. Further, a maximum <span class="math"><math>ηSTH</math></span> = 26% has been obtained by optimizing the parameters in predefined ranges, which is 7% higher than the state-of-the-art of the solar HTE with TES. Based on a preliminary techno-economic analysis, the capital cost of the proposed system is estimated to be 9.28 $/kg H<sub>2</sub>, which is 18.9% lower than a typical photovoltaic based electrolyzer system. Therefore, the proposed system is economically feasible.</p>
energy & fuels,thermodynamics,mechanics
What problem does this paper attempt to address?