Abstract:The results of spectrometry with an ASD FieldSpec 3 FR spectroradiometer at wavelengths ranging from 350 to 2500 nm for hydrogenated amorphous and crystalline titanium and zirconium diborides are presented. The results were used to determine changes in the spectral characteristics of hydrogen in bulk and film TiB 2 and ZrB 2 . The spectrometry was performed with the contact method using a Unit Contact Probe. The bulk test samples and spraying targets were prepared by the powder metallurgy method. X-ray diffraction identified that the samples had crystalline structure. Thin films of titanium and zirconium diborides were produced by magnetron sputtering of TiB 2 and ZrB 2 targets in an argon atmosphere. The structure of the films was studied using an EMP-100 electron diffractometer employing the transmission method at a residual pressure of ~7 ∙ 10 –3 Pa. The electron diffraction patterns showed a strong 'halo' at the center, being indicative of amorphous structure of the films, promoting hydrogen transfer process. The samples were hydrogenated from the gas phase at a hydrogen pressure of 0.1 MPa and a temperature of 870 K. A critical analysis of published methods for the quantitative determination of hydrogen in high-temperature borides was provided. The spectrometry method is advantageous in that it is fast, precise, nondestructive, and surface-sensitive, and the entire spectrum is displayed in real time. The intensities of the Brackett B β and Balmer H β hydrogen lines for crystalline and amorphous TiB 2 were compared, and the absorption of hydrogen by the crystalline sample was found to be 4.1 times higher than that by the amorphous one. In polycrystalline TiB 2 , lines with a halfwidth of 200–300 nm were observed at 500 and 750 nm, which was explained by the subbarrier tunneling of hydrogen atoms between neighboring interstitials, ranging, in particular, for many lattice parameters. The absorbed hydrogen amount in the amorphous film was 1.4 times higher than on the starting film. Magnetron sputtering of ceramic targets was known to lead to the introduction of impurities several tens of nanometers in size (short-range crystalline ordering) into the film, to which the hydrogen penetration process was sensitive. The presence of hydrogen atoms resulted in spectral bell-like curves, partially overlapping each other. By analogy with metal amorphous alloys, the shape of these curves could be explained by quasi-interstices. In the amorphous titanium diboride, a bell-like Balmer H β curve was observed, confirming short-range crystalline ordering. Correlation between the hydrogen absorption and the lattice energy and bonding energy of Me–B atoms was established. When hydrogen was absorbed by crystalline titanium and zirconium diborides, TiB 2 was found to absorb higher amounts of hydrogen because of lower lattice energy and Ti–B atomic bond energy. As the spectroradiometer method is prompt and informative, we can recommended it for the identification of hydrogenated amorphous and crystalline ceramic materials.

Comparative Studies of Hydrogen Dissolution and Release Behavior in Zirconate Oxides by TDS and TMAP4 Analysis

Evaluation of the hydrogen solubility and diffusivity in proton-conducting oxides by converting the PSL values of a tritium imaging plate

Deep Insight of Unique Phase Transition Behaviors and Mechanism in Zr 2 Co-H Isotope System with Ultra-Low Equilibrium Pressure

Study on the hydrogen behavior in Y and Co doped barium-zirconate

High-throughput Computing for Hydrogen Transport Properties in Ε-Zrh2

Isotopic effect of proton conductivity in barium-zirconates for various hydrogen-containing atmospheres

Study of hydrogen sorption and desorption processes of zirconium beryllide ZrBe 2

Synthesis and Characterization of Doped Nano-Sized Ceria–zirconia Solid Solutions

Determination of Hydrogen in Hydrogenated Titanium and Zirconium Diborides using an ASD Fieldspec 3 FR Spectroradiometer

Local distortions and dynamics in hydrated Y-doped BaZrO$_3$

Effect of Oxygen on Hydrogen Diffusivity in hcp-Zirconium

On the zirconium–oxygen–hydrogen ternary system

Implication for the preservation of hydrogen in the upper mantle and impact 3 on electrical conductivity

First-principles study on the dissolution and diffusion properties of hydrogen in α-Al2O3

Effect of Ti Substitution on Hydrogen Storage Properties of Zr1−xTixCo (x = 0, 0.1, 0.2, 0.3) Alloys

Investigation on properties of BaZr0.6Hf0.2Y0.2O3-δ with sintering aids (ZnO, NiO, Li2O) and its application for hydrogen permeation

Peculiarities of Application of the Gas Extraction Method for Determination of Hydrogen Content in Samples of Irradiated Zirconium Materials

Hydrogen Degassing of Zirconium under High-Vacuum Conditions

MICROSTRUCTURES AND HYDROGEN STORAGE PROPERTIES OF Ti0.7Zr0.3(Cr1-xVx)2 ALLOYS

An electrochemical technique for controlled dissolution of zirconium based components of light water reactors

Yttria-Stabilized Zirconia Composite Coating as Barrier to Reduce Hydrogen Permeation into Steel