Abstract:This work was part of a feasibility study of developing SPECT imaging capability on a lutetium oxyorthosilicate (LSO)-based animal PET system. The SPECT aspect of the system was enabled by inserting a collimator assembly inside the detector ring and acquiring data in singles mode. The LSO detectors were used for both PET and SPECT imaging. The intrinsic radioactivity of 176 Lu in the LSO crystals, however, contaminates the SPECT data more severely than for PET imaging. This work was to study the imaging characteristics of the intrinsic LSO activity, the effects of correction, and the minimal activity level required for usable SPECT imaging. To understand the structural and noise patterns of LSO activity in images, measured high counts projections from LSO activity only and simulated multiple-replicates of low counts projections from LSO activity with and without a uniform phantom in the field-of-view (FOV) were reconstructed. To identify the minimal activity levels needed for obtaining useful tomographic images with the existence of LSO activity, we derived a formula to estimate the minimal activity in the FOV of one detector crystal ring that would yield a net detectable signal in projection data. A series of phantoms with different activity distribution patterns and total activity levels were scanned for variable length of time through simulation and experiments. The LSO contributions to each study were estimated from a long LSO background acquisition dataset and corrected prior to iterative image reconstruction. The LSO activity showed up as concentric rings in a reconstructed tomographic image. The LSO activity estimation and correction method was effective and it reduced the activity level required for producing images with expected visual patterns to about V* of the level needed without the correction. The minimal activity levels predicted by the projection data based formula correlated well with the activity levels needed for obtaining visible image patterns - observed in simulated and experimental studies. Phantom studies demonstrated that while image quality was dependent on source distribution pattern, activity level, and acquisition time, SPECT imaging on LSO based animal PET is feasible with practical dose level and acquisition time used in animal imaging.

Evaluation of cerium doped lutetium oxyorthosilicate (LSO) scintillation crystals for PET

INVESTIGATION OF LSO SCINTILLATORS FOR HIGH-RESOLUTION PET DETECTORS

Timing advances of commercial divalent-ion co-doped LYSO:Ce and SiPMs in sub-100 ps time-of-flight positron emission tomography

Sub-100 ps coincidence time resolution for positron emission tomography with LSO:Ce codoped with Ca

Performance comparison of dual-ended readout depth-encoding PET detectors based on BGO and LYSO crystals

BGO as a hybrid scintillator / Cherenkov radiator for cost-effective time-of-flight PET

Collection of scintillation light from small BGO crystals

Performance of a High-Resolution Depth Encoding PET Detector Using Barium Sulfate Reflector.

Requirements of Scintillation Crystals with the Development of PET Scanners

Effect of Crystal surface treatment on the timing response of a DOI detector for PET

A high resolution SPECT detector based on thin continuous LYSO

Lutetium Oxyorthosilicate (LSO) Intrinsic Activity Correction and Minimal Detectable Target Activity Study for SPECT Imaging with a LSO-based Animal PET Scanner

Determination of lutetium density in LYSO crystals: methodology and PET detector applications

Lutetium oxyorthosilicate (LSO) intrinsic activity correction and minimal detectable target activity study for SPECT imaging with a LSO-based animal PET scanner.

Effects of LSO Detector Intrisic Radioactivity on SPECT Imaging

On timing-optimized SiPMs for Cherenkov detection to boost low cost time-of-flight PET

Optimization Of Crystal Surface Treatment For A Double Layer Depth Of Interaction Detector

Optimum performance investigation of LYSO crystal pixels: A comparison between GATE simulation and experimental data

Investigation of the Time Performance of a LYSO Array for TOF-PET

Development of a Depth of Interaction Detector for Γ-Rays

Nanocrystalline Lead Halide Perovskites to Boost Time‐of‐Flight Performance of Medical Imaging Detectors