Abstract:Plane-strain (or straight-line) bending is a major sheet-forming operation. Precise prediction of springback is a key to designing bending dies, to controlling the process and the press, and to assessing the accuracy of part geometry. In this paper, a complete theory and reliable mathematical models for plane-strain sheet bending have been established to predict springback, bendability or the minimum bending ratio (R/t), strain and stress distributions, and the maximum loads on the punch and the die. The elastoplastic bending model incorporates the true (non-linear) strain distribution across the sheet thickness. Swift's strain-hardening law, Hill's (1979) non-quadratic yield criterion for normal and planar anisotropic materials, and the plane-strain deformation mode. A computer code called “BEND” has been developed to simulate the air bending and die bending processes with a U-die, a V-die, and a wiping-die. Simulation results were compared to experimental data, good agreement being observed. Air bending simulations show that the springback angle is proportional to the bending moment and the bent arc length between the punch and the die. The bending moment is greater for materials with higher strength, strain hardening and normal anisotropy, which increase the springback. For such materials, decreasing the bent arc length by reducing the die opening or die clearance is an effective way to reduce the springback. In air bending, springback can be compensated for by overbending through a deeper punch stroke and the necessary stroke can be preset in the press controller using the predicted curve of springback vs. stroke.

Prediction of Minimum Bending Ratio of Aluminum Sheets From Tensile Material Properties

Prediction of failure in bending of an aluminium sheet alloy

Bending Limit Prediction of an Aluminum Thin Sheet

ALUMINUM ALLOY WHEEL BENDING TEST FATIGUE LIFE PREDICTION

Modeling material behavior of AA5083 aluminum alloy sheet using biaxial tensile tests and its application in numerical simulation of deep drawing

A Study to Predict Failure in Biaxially Stretched Sheets of Aluminum Alloy 2024-T3

Prediction of limit strains in hot forming of aluminium alloy sheets

Mathematical modeling of plane-strain bending of sheet and plate

Finite element method for minimizing geometric error in the bending of large sheets

Development of an Anisotropic Failure Criterion for Characterising the Influence of Curvature on Forming Limits of Aluminium Sheet Metal Alloys

Ductile Failure Predictions for the Three-Point Bending Test of a Complex Geometry Made From Aluminum Alloy

Experimental and numerical investigation of failure during bending of AA6061 aluminum alloy sheet using the modified Mohr-Coulomb fracture criterion

Semi-Analytical Solution Model for Bending Deformation of T-Shaped Aviation Aluminium Alloy Components under Residual Stress

Influence of ductile damage on the bending behaviour of aluminium alloy thin sheets

Investigation on bending failure to characterize crashworthiness of 6xxx-series aluminium sheet alloys with bending-tension test procedure

Predicting Plastic Behavior of Magnesium Alloy Tube Bending with Comprehensive Constitutive Models

Numerical prediction and experimental validation of forming limit curves of laminated half-hard aluminum sheets

On the Failure Prediction of Dual-Phase Steel and Aluminium Alloys Exposed to Combined Tension and Bending

Influence of Material Models on the Accuracy of the Sheet Forming Simulation

A Physical-Based Plane Stress Constitutive Model for High Strength AA7075 under Hot Forming Conditions