Two-Dimensional Sb Modified TiO2 Nanorod Arrays as Photoanodes for Efficient Solar Water Splitting

Jie Gao,Shengqi Zhang,Xiaoqing Ma,Yi Sun,Xiaoyan Zhang
DOI: https://doi.org/10.3390/nano13071293
IF: 5.3
2023-04-06
Nanomaterials
Abstract:As one of the widely studied semiconductor materials, titanium dioxide (TiO2) exhibits high photoelectrochemical (PEC) water-splitting performance as well as high chemical and photo stability. However, limited by a wide band gap and fast electron-hole recombination rate, the low solar-to-hydrogen conversion efficiency remains a bottleneck for the practical application of TiO2-based photoelectrodes. To improve the charge separation and water oxidation efficiency of TiO2 photoanodes, antimonene, a two-dimensional (2D) material obtained by liquid-phase exfoliation, was assembled onto TiO2 nanorod arrays (TNRAs) by a simple drop-coating assembly process. PEC measurements showed that the resulting 2D Sb/TiO2 photoelectrode displayed an enhanced photocurrent density of about 1.32 mA cm−2 in 1.0 M KOH at 0.3 V vs. Hg/HgO, which is ~1.65 times higher than that of the pristine TNRAs. Through UV-Vis absorption and electrochemical impedance spectroscopy measurements, it was possible to ascribe the enhanced PEC performances of the 2D Sb/TiO2 photoanode to increased absorption intensity in the visible light region, and improved interfacial charge-transfer kinetics in the 2D Sb/TiO2 heterojunction, which promotes electron-hole separation, transfer, and collection.
materials science, multidisciplinary,physics, applied,nanoscience & nanotechnology,chemistry
What problem does this paper attempt to address?
The problem this paper attempts to address is improving the performance of titanium dioxide (TiO₂) photoanodes in photoelectrochemical (PEC) water splitting. Specifically, TiO₂, as a widely used semiconductor material, exhibits high performance and stability in PEC water splitting. However, due to its large bandgap and fast electron-hole recombination rate, the solar-to-hydrogen conversion efficiency is low, which becomes a bottleneck issue in practical applications. To improve the charge separation and water oxidation efficiency of TiO₂ photoanodes, researchers prepared 2D antimony (Sb) nanosheets using a liquid-phase exfoliation method and assembled them onto TiO₂ nanorod arrays through a simple drop-casting assembly process. Experimental results show that this 2D Sb/TiO₂ photoanode exhibits enhanced photocurrent density of approximately 1.32 mA cm⁻² at 0.3 V vs. Hg/HgO in 1.0 M KOH solution, which is about 1.65 times higher than that of the original TiO₂ nanorod arrays. Through UV-Vis absorption spectra and electrochemical impedance spectroscopy measurements, it was found that the enhanced PEC performance of the 2D Sb/TiO₂ photoanode is mainly attributed to the increased absorption intensity in the visible light region and the improved interfacial charge transfer dynamics in the 2D Sb/TiO₂ heterojunction, thereby promoting the separation, transport, and collection of electron-hole pairs.