Abstract:A composite titania thin film consisted of quasi-aligned single-crystalline rutile nanorods embedded in sol-gel-derived anatase aggregates was fabricated and its photoelectrochemical behavior was studied in detail. A monolayer of nearly sing I e-crystal line rutile nanorods was first deposited on metallic Ti substrates through a controlled reaction between Ti and hydrogen peroxide. The gaps among the rutile nanorods were then filled with titania nanoparticles through a sol-gel dip-coating approach, which achieved a composite thin film of single-crystalline rutile nanorods embedded in anatase aggregates, after a subsequent thermal treatment at 723 K. The X-ray diffraction measurement revealed that the composite film with thickness of 180 nm contained anatase and rutile in a nearly 50:50 ratio. The UV-visible diffusive reflectance spectra estimated a band gap of 2.99 eV for the rutile monolayer and a slightly increased value of 3.03 eV for the composite film due to the embedding of the anatase nanoparticles. Photocurrent versus potential diagrams, photocurrent transient curves, and open-circuit potential measurement supported the fact that the anatase nanoparticles possessed better inherent photoelectrochemical properties than rutile. However, electrochemical impedance spectra characterization, together with photocurrent transient curves and open-circuit potential measurement, suggests that the single-crystalline rutile nanorods exhibited a higher electron-transfer rate. The combination of the two components in such an appropriate way enhanced significantly the charge separation effect arising from the anatase/rutile couple, which hence combined efficiently the "mixed crystal effect" and the "mixed morphological effect". A steady-state photocurrent more than double the simple sum of those generated by the two components alone was detected for the current composite film, which can be attributed to the single-crystalline rutile nanorods that provide channels for rapid electron transfer to the conductive Ti substrates under an applied bias potential. As a result, this study concludes that the present nanostructure magnified significantly the well-established mixed crystal effect, that is, an enhanced charge separation arising from a mixture of anatase and rutile.

Balsam-Pear-Like Rutile/Anatase Core/Shell Titania Nanorod Arrays For Photoelectrochemical Water Splitting

CdS/ZnS Co-Sensitized Hierarchical TiO2Nanotree Array with Rutile/Anatase Junctions for Enhanced Photoelectrochemical Performance

Single-crystal TiO 2 /srtio 3 Core–shell Heterostructured Nanowire Arrays for Enhanced Photoelectrochemical Performance

Heterostructured TiO2 Nanorod@Nanobowl Arrays for Efficient Photoelectrochemical Water Splitting.

Novel TiO2/Bi4Ti3O12 nanorod arrays decorated with Co-Pi for boosted solar photoelectrochemical water splitting

Facile Synthesis of Ni-doped TiO2ultrathin Nanobelt Arrays with Enhanced Photocatalytic Performance

Enhanced Photoelectrochemical Response of a Composite Titania Thin Film with Single-Crystalline Rutile Nanorods Embedded in Anatase Aggregates

Surface Energy-Driven Solution Epitaxial Growth of Anatase TiO2 Homostructures for Overall Water Splitting

Two-Dimensional Sb Modified TiO2 Nanorod Arrays as Photoanodes for Efficient Solar Water Splitting

Piezoelectric‐Effect‐Enhanced Full‐Spectrum Photoelectrocatalysis in P–n Heterojunction

Core-shell hetero-phase reduced Ti–Ni–O nanotubes photoanode with enhanced optical absorption and charge transport for boosted photoelectrochemical water splitting

Regulating Phase Junction and Oxygen Vacancies of TiO2 Nanoarrays for Boosted Photoelectrochemical Water Oxidation

Bifunctional Single-Crystalline Rutile Nanorod Decorated Heterostructural Photoanodes For Efficient Dye-Sensitized Solar Cells

Ta-Doped Porous TiO2 Nanorod Arrays by Substrate-Assisted Synthesis: Efficient Photoelectrocatalysts for Water Oxidation

Titanium Dioxide Nano-Heterostructure with Nanoparticles Decorating Nanowires for High-Performance Photocatalysis

Surface Polaron States on Single-Crystal Rutile TiO2 Nanorod Arrays Enhancing Charge Separation and Transfer

An Efficient Photocatalyst with Pt/TiO2@CdS/Co3O4 Hollow Core–Shell Nanostructure for Overall Water Splitting

Surface Engineered Doping of Hematite Nanorod Arrays for Improved Photoelectrochemical Water Splitting

Enhanced photoelectrochemical performance of NiS-modified TiO 2 nanorods with a surface charge accumulation facet

Sb-Doped SnO2 Nanorods Underlayer Effect to the α-Fe2 O3 Nanorods Sheathed with TiO2 for Enhanced Photoelectrochemical Water Splitting

Surface plasmon resonance metal-coupled biomass carbon modified TiO2 nanorods for photoelectrochemical water splitting