Influence of stress wave incident angles on spalling failure in rock–mortar composites: experimental and simulation study

Yunfan Bai,Shiming Wang,Yan Shen,Jiaqi Wang,Qiuhong Wu,Jian Zhou,Chuanqi Li

DOI: https://doi.org/10.1007/s43452-024-00917-6

IF: 4.042

2024-04-08

Archives of Civil and Mechanical Engineering

Abstract:This paper aims to reveal the influence of stress wave incidents at different angles on surrounding rock and supporting mortar. The split Hopkinson pressure bar device with a diameter of 50 mm was used to carry out the spall failure test of rock–mortar composite specimens under the incident stress wave at the angel of 30°, 45°, 60°, and 90°, and the spall failure process of the specimens was recorded by a high-speed camera. The test results show that the incident angle of the stress wave is an important factor in determining the initial spalling position and spalling strength. Oblique incidence increases the number of reflections of the stress wave in mortar resulting in the stress state of mortar being different. Under the same impact conditions, with the decrease of the incident angle, the distance between the initial spalling position and the free end of the specimen increases, and the maximum initial spalling position is obtained at the incident angle of 30°. The incident angle is positively correlated with the specimen spalling strength, and the maximum spall strength is obtained at the incident angle of 90°. In addition, the simulation results provided by Particle Flow Code were in good agreement with the test results. The simulation reflects that the spalling failure degree is affected by the incident angle of the stress wave, and the number of spalling layers of the specimens increases with the increase of the oblique incident angle. This paper can provide a reference for the excavation support design of underground engineering.

engineering, mechanical,materials science, multidisciplinary, civil