Abstract:Although it has been demonstrated that heterogeneous film can enhance adhesion properties without modifying the interface, there is still a dearth of comprehensive studies in the literature regarding the peeling process of such film and the potential instability that may occur during the peeling process. To address these issues, a peeling model based on the cohesion zone model and Euler-Bernoulli beam equation is proposed in this study. Our analysis revealed four previously unknown peeling behaviors: Firstly, there are nine kinds of peeling processes for heterogeneous film. Only one is stable, static peeling process, while the other eight exhibit instability when the peeling front reaches a certain position. Secondly, instability may occur at the interface from the stiff section to the compliant section of the homogeneous film, as well as at stiff section or compliant section. Moreover, two of these peeling processes experience two instabilities within one peeling period - one at the interface from the stiff section to the compliant section and another at stiff section. Thirdly, an optimal length fraction of the stiff section for enhancing adhesive performance exists and its value is largely determined by the strength of the interface material. Specifically, higher interfacial strength results in smaller values of the optimal length fraction. Finally, the maximum peeling force is positively correlated with the bending stiffness ratio, interfacial strength, interfacial toughness, and period length of heterogeneous film. But it is inversely related to the bending stiffness. These findings are crucial for understanding the peeling behavior of heterogeneous film and strongly adhesive interfaces found in nature, and can be applied to optimize adhesive design and performance in practical engineering applications.

Competition between delamination and fracture in multiple peeling problems

Steered Molecular Dynamics Simulation of the Detaching Process of Two Parallel Surfaces Glued Together by a Single Polyethylene Chain

Viscoelastic peeling of thin tapes with frictional sliding

The Theory of Multiple Peeling

Tuning the periodic V-peeling behavior of elastic tapes applied to thin compliant substrates

Non-linear double-peeling: experimental vs. theoretical predictions

Investigation of the Peeling and Pull-off Behavior of Adhesive Elastic Fibers via a Novel Computational Beam Interaction Model

Fatigue-Resistant Adhesion Through High Energy Barriers

The role of interfacial friction on the peeling of thin viscoelastic tapes

Modelling the non-steady peeling of viscoelastic tapes

Peeling an elastic film from a soft viscoelastic adhesive: experiments and scaling laws

Toughening and Asymmetry in Peeling of Heterogeneous Adhesives

Peeling from a patterned thin elastic film

Delamination from an adhesive sphere: Curvature-induced dewetting versus buckling

Peeling dynamics of fluid membranes bridged by molecular bonds: moving or breaking

Multiple kinds of peeling processes and instabilities in heterogeneous film peeling

Rate-Dependent Pattern Evolution in Peeling Adhesive Tape Driven by Cohesive Failure

Peeling pressure-sensitive adhesive elastica from elastica with pinned and roller ends

From Fibrils to Toughness: Multi-Scale Mechanics of Fibrillating Interfaces in Stretchable Electronics

Effect of Interfacial Slippage in Peel Test: Theoretical Model.