Abstract:The detection of depth-of-interaction (DOI) is a critical detector capability to improve the PET spatial resolution uniformity across the field-of-view and will significantly enhance, in particular, small bore system performance for brain, breast, and small animal imaging. One promising technique of DOI detection is to use dual-ended-scintillator readout that uses two photon sensors to detect scintillation light from both ends of a scintillator array and estimate DOI based on the ratio of signals (similar to Anger logic). This approach needs a careful DOI function calibration to establish accurate relationship between DOI and signal ratios, and to recalibrate if the detection condition is shifted due to the drift of sensor gain, bias variations, or degraded optical coupling, etc. However, the current calibration method that uses coincident events to locate interaction positions inside a single scintillator crystal has severe drawbacks, such as complicated setup, long and repetitive measurements, and being prone to errors from various possible misalignments among the source and detector components. This method is also not practically suitable to calibrate multiple DOI functions of a crystal array. To solve these problems, a new method has been developed that requires only a uniform flood source to irradiate a crystal array without the need to locate the interaction positions, and calculates DOI functions based solely on the uniform probability distribution of interactions over DOI positions without knowledge or assumption of detector responses. Simulation and experiment have been studied to validate the new method, and the results show that the new method, with a simple setup and one single measurement, can provide consistent and accurate DOI functions for the entire array of multiple scintillator crystals. This will enable an accurate, simple, and practical DOI function calibration for the PET detectors based on the design of dual-ended-scintillator readout. In addition, the new method can be generally applied to calibrating other types of detectors that use the similar dual-ended readout to acquire the radiation interaction position.

Absolute self-calibration of single-photon and multiplexed photon-number-resolving detectors

Quantum Efficiency Calibration of Opto-Electronic Detector by Means of Correlated Photons Method

Measuring the absolute photo detection efficiency using photon number correlations

Benchmarking photon number resolving detectors

Improved Photon Counting Efficiency Calibration Using Superconducting Single Photon Detectors

Photon Number Resolving Detection with a Single-Photon Detector and Adaptive Storage Loop

Responsivity evaluation of photonics integrated photodetectors via pairwise measurements with an attenuation circuit

Effects of multi-photon states in the calibration of single-photon detectors based on a portable bi-photon source

Verification of calibration methods for determining photon-counting detection efficiency using superconducting nano-wire single photon detectors

Analysis of a photon number resolving detector based on an ion Coulomb crystal inside an optical cavity

Single-shot number-resolved detection of microwave photons with error mitigation

Linearly Multiplexed Photon Number Resolving Single-photon Detectors Array

A high dynamic range optical detector for measuring single photons and bright light

A Novel Method to Calibrate Doi Function of A Pet Detector with A Dual-Ended-Scintillator Readout

Multiparameter estimation with single photons

Energy Calibration of Photon Counting Detectors Using a Single Monochromatic Source

Detecting Infrared Single Photons with Near-Unity System Detection Efficiency

Fundamental Limits to Single-Photon Detection Determined by Quantum Coherence and Backaction

Integrated photonics cascaded attenuation circuit towards single-photon detector calibration