Abstract:When first introduced, single-photon counting detectors reshaped crystallography at synchrotrons. Their fast readout speed enabled, for example, shutter-less data collection and fine slicing of the rotation angle and boosted the development of new experimental techniques like ptychography. Under optimal conditions, single-photon counting detectors provide an unlimited dynamic range with image noise only limited by the Poisson statistics of the incoming photons. Counting the pulses from individual photons, essentially what made the detectors so successful, also causes the main drawback, which is the loss of efficiency at high photon fluxes due to pulse pileup in the analog front end. To fully take advantage of diffraction-limited light sources, the next-generation single-photon counters need to improve their count rate capabilities in the same order of magnitude as the increased flux. Moreover, fast frame rates (a few kHz) are required to cope with the shorter dwell time achievable, thanks to the higher flux. Detector architecture with multiple comparators and counters can open new possibilities for energy-resolved imaging, while interpixel communication can overcome the issues arising from charge sharing and reduce the loss of efficiency at the pixel corners. Coupling single-photon counting detectors to high-Z sensors for hard X-ray detection ( > 20 keV) and to low-gain avalanche diodes (LGADs) for soft X-rays is also necessary to make use of the increased coherence of the new light sources over the full radiation spectrum. In this paper, we present possible strategies to improve the performance of single-photon counting detectors at the fourth-generation synchrotron sources and compare them to charge integrating detectors.

Improved Photon Counting Efficiency Calibration Using Superconducting Single Photon Detectors

Ultra-broadband Microfiber-Coupled Superconducting Single-Photon Detector

Quantum Efficiency Calibration of Opto-Electronic Detector by Means of Correlated Photons Method

Verification of calibration methods for determining photon-counting detection efficiency using superconducting nano-wire single photon detectors

Counting Rate Enhancements in Superconducting Nanowire Single-Photon Detectors with Improved Readout Circuits

A Calibration Method for Photon Counters Using A Customized Standard Light Source

A High Speed and High Efficiency Superconducting Photon Number Resolving Detector

Photon-Counting Spectrometers Based on Superconducting Nanowire Single-Photon Detectors

Probabilistic Energy-to-Amplitude Mapping in a Tapered Superconducting Nanowire Single-Photon Detector

Absolute self-calibration of single-photon and multiplexed photon-number-resolving detectors

Detecting Infrared Single Photons with Near-Unity System Detection Efficiency

Time-walk and jitter correction in SNSPDs at high count rates

Few-photon imaging at 1550 nm using a low-timing-jitter superconducting nanowire single-photon detector

A free-space coupled, large-active-area superconducting microstrip single-photon detector for photon-counting time-of-flight imaging

Effects of multi-photon states in the calibration of single-photon detectors based on a portable bi-photon source

Energy Calibration of Photon Counting Detectors Using a Single Monochromatic Source

High Performance Superconductor Single Photon Detector with Enhanced System Efficiency at Infrared Wavelength

Investigation of the Performance of an Ultralow-Dark-Count Superconducting Nanowire Single-Photon Detector

Improving photon number resolvability of a superconducting nanowire single-photon detector array using a level comparator circuit

Readout-efficient Superconducting Nanowire Single-Photon Imager with Orthogonal Time–amplitude Multiplexing by Hotspot Quantization

Single-photon counting detectors for diffraction-limited light sources